[PATCH v2 2/7] phy: miphy365x: Pass sysconfig register offsets via syscfg dt property.

Kishon Vijay Abraham I kishon at ti.com
Fri Jan 30 02:35:42 PST 2015


Hi,

On Wednesday 07 January 2015 08:34 PM, Peter Griffin wrote:
> Based on Arnds review comments here https://lkml.org/lkml/2014/11/13/161,
> update the miphy365 phy driver to access sysconfig register offsets via
> syscfg dt property.
> 
> This is because the reg property should not be mixing address spaces
> like it does currently for miphy365. This change then also aligns us
> to how other platforms such as keystone and bcm7445 pass there syscon
> offsets via DT.
> 
> This patch breaks DT compatibility, but this platform is considered WIP,
> and is only used by a few developers who are upstreaming support for it.
> This change has been done as a single atomic commit to ensure it is
> bisectable.

I'm dropping this from my tree since I didn't get Ack from
"arch/arm/boot/dts/stih416.dtsi" Maintainer.

Thanks
Kishon
> 
> Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
> Reviewed-by: Arnd Bergmann <arnd at arndb.de>
> ---
>  .../devicetree/bindings/phy/phy-miphy365x.txt      | 15 +++++------
>  arch/arm/boot/dts/stih416.dtsi                     | 10 ++++----
>  drivers/phy/phy-miphy365x.c                        | 29 ++++++++--------------
>  3 files changed, 23 insertions(+), 31 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/phy/phy-miphy365x.txt b/Documentation/devicetree/bindings/phy/phy-miphy365x.txt
> index 42c8808..9802d5d 100644
> --- a/Documentation/devicetree/bindings/phy/phy-miphy365x.txt
> +++ b/Documentation/devicetree/bindings/phy/phy-miphy365x.txt
> @@ -6,8 +6,10 @@ for SATA and PCIe.
>  
>  Required properties (controller (parent) node):
>  - compatible    : Should be "st,miphy365x-phy"
> -- st,syscfg     : Should be a phandle of the system configuration register group
> -		  which contain the SATA, PCIe mode setting bits
> +- st,syscfg     : Phandle / integer array property. Phandle of sysconfig group
> +		  containing the miphy registers and integer array should contain
> +		  an entry for each port sub-node, specifying the control
> +		  register offset inside the sysconfig group.
>  
>  Required nodes	:  A sub-node is required for each channel the controller
>  		   provides. Address range information including the usual
> @@ -26,7 +28,6 @@ Required properties (port (child) node):
>  		  registers filled in "reg":
>  			- sata:   For SATA devices
>  			- pcie:   For PCIe devices
> -			- syscfg: To specify the syscfg based config register
>  
>  Optional properties (port (child) node):
>  - st,sata-gen	     :	Generation of locally attached SATA IP. Expected values
> @@ -39,20 +40,20 @@ Example:
>  
>  	miphy365x_phy: miphy365x at fe382000 {
>  		compatible      = "st,miphy365x-phy";
> -		st,syscfg  	= <&syscfg_rear>;
> +		st,syscfg  	= <&syscfg_rear 0x824 0x828>;
>  		#address-cells	= <1>;
>  		#size-cells	= <1>;
>  		ranges;
>  
>  		phy_port0: port at fe382000 {
> -			reg = <0xfe382000 0x100>, <0xfe394000 0x100>, <0x824 0x4>;
> -			reg-names = "sata", "pcie", "syscfg";
> +			reg = <0xfe382000 0x100>, <0xfe394000 0x100>;
> +			reg-names = "sata", "pcie";
>  			#phy-cells = <1>;
>  			st,sata-gen = <3>;
>  		};
>  
>  		phy_port1: port at fe38a000 {
> -			reg = <0xfe38a000 0x100>, <0xfe804000 0x100>, <0x828 0x4>;;
> +			reg = <0xfe38a000 0x100>, <0xfe804000 0x100>;;
>  			reg-names = "sata", "pcie", "syscfg";
>  			#phy-cells = <1>;
>  			st,pcie-tx-pol-inv;
> diff --git a/arch/arm/boot/dts/stih416.dtsi b/arch/arm/boot/dts/stih416.dtsi
> index fad9073..85afe01 100644
> --- a/arch/arm/boot/dts/stih416.dtsi
> +++ b/arch/arm/boot/dts/stih416.dtsi
> @@ -283,21 +283,21 @@
>  
>  		miphy365x_phy: phy at fe382000 {
>  			compatible      = "st,miphy365x-phy";
> -			st,syscfg  	= <&syscfg_rear>;
> +			st,syscfg	= <&syscfg_rear 0x824 0x828>;
>  			#address-cells	= <1>;
>  			#size-cells	= <1>;
>  			ranges;
>  
>  			phy_port0: port at fe382000 {
>  				#phy-cells = <1>;
> -				reg = <0xfe382000 0x100>, <0xfe394000 0x100>, <0x824 0x4>;
> -				reg-names = "sata", "pcie", "syscfg";
> +				reg = <0xfe382000 0x100>, <0xfe394000 0x100>;
> +				reg-names = "sata", "pcie";
>  			};
>  
>  			phy_port1: port at fe38a000 {
>  				#phy-cells = <1>;
> -				reg = <0xfe38a000 0x100>, <0xfe804000 0x100>, <0x828 0x4>;
> -				reg-names = "sata", "pcie", "syscfg";
> +				reg = <0xfe38a000 0x100>, <0xfe804000 0x100>;
> +				reg-names = "sata", "pcie";
>  			};
>  		};
>  
> diff --git a/drivers/phy/phy-miphy365x.c b/drivers/phy/phy-miphy365x.c
> index 6ab43a8..6c80154 100644
> --- a/drivers/phy/phy-miphy365x.c
> +++ b/drivers/phy/phy-miphy365x.c
> @@ -141,7 +141,7 @@ struct miphy365x_phy {
>  	bool pcie_tx_pol_inv;
>  	bool sata_tx_pol_inv;
>  	u32 sata_gen;
> -	u64 ctrlreg;
> +	u32 ctrlreg;
>  	u8 type;
>  };
>  
> @@ -179,7 +179,7 @@ static int miphy365x_set_path(struct miphy365x_phy *miphy_phy,
>  	bool sata = (miphy_phy->type == MIPHY_TYPE_SATA);
>  
>  	return regmap_update_bits(miphy_dev->regmap,
> -				  (unsigned int)miphy_phy->ctrlreg,
> +				  miphy_phy->ctrlreg,
>  				  SYSCFG_SELECT_SATA_MASK,
>  				  sata << SYSCFG_SELECT_SATA_POS);
>  }
> @@ -445,7 +445,6 @@ int miphy365x_get_addr(struct device *dev, struct miphy365x_phy *miphy_phy,
>  {
>  	struct device_node *phynode = miphy_phy->phy->dev.of_node;
>  	const char *name;
> -	const __be32 *taddr;
>  	int type = miphy_phy->type;
>  	int ret;
>  
> @@ -455,22 +454,6 @@ int miphy365x_get_addr(struct device *dev, struct miphy365x_phy *miphy_phy,
>  		return ret;
>  	}
>  
> -	if (!strncmp(name, "syscfg", 6)) {
> -		taddr = of_get_address(phynode, index, NULL, NULL);
> -		if (!taddr) {
> -			dev_err(dev, "failed to fetch syscfg address\n");
> -			return -EINVAL;
> -		}
> -
> -		miphy_phy->ctrlreg = of_translate_address(phynode, taddr);
> -		if (miphy_phy->ctrlreg == OF_BAD_ADDR) {
> -			dev_err(dev, "failed to translate syscfg address\n");
> -			return -EINVAL;
> -		}
> -
> -		return 0;
> -	}
> -
>  	if (!((!strncmp(name, "sata", 4) && type == MIPHY_TYPE_SATA) ||
>  	      (!strncmp(name, "pcie", 4) && type == MIPHY_TYPE_PCIE)))
>  		return 0;
> @@ -606,7 +589,15 @@ static int miphy365x_probe(struct platform_device *pdev)
>  			return ret;
>  
>  		phy_set_drvdata(phy, miphy_dev->phys[port]);
> +
>  		port++;
> +		/* sysconfig offsets are indexed from 1 */
> +		ret = of_property_read_u32_index(np, "st,syscfg", port,
> +					&miphy_phy->ctrlreg);
> +		if (ret) {
> +			dev_err(&pdev->dev, "No sysconfig offset found\n");
> +			return ret;
> +		}
>  	}
>  
>  	provider = devm_of_phy_provider_register(&pdev->dev, miphy365x_xlate);
> 



More information about the linux-arm-kernel mailing list