[PATCH v2] MediaTek PMIC support

[Sascha Hauer]

On Thu, Jan 29, 2015 at 04:44:19PM +0100, Matthias Brugger wrote:
> 2015-01-29 15:27 GMT+01:00 Sascha Hauer <s.hauer at pengutronix.de>:
> > On Thu, Jan 29, 2015 at 01:39:42PM +0100, Matthias Brugger wrote:
> >> Hi Sascha,
> >>
> >> 2015-01-26 12:47 GMT+01:00 Sascha Hauer <s.hauer at pengutronix.de>:
> >> > Olof, Arnd,
> >> >
> >> > OK to put the driver into drivers/soc/mediatek? Can you take these
> >> > patches?
> >>
> >> How does this patches fit together with the one James clock framework patches?
> >> Both use the same compatible "mediatek,mt8135-infracfg" and
> >> "mediatek,mt8135-pericfg".
> >>
> >> I had a look on other implementations and they attach the reset
> >> controller to the clk driver, if they share the same hw block.
> >> Might we run into problems if we implement the clocks in the mfd, as
> >> we need the clocks early in boot (e.g. for the timer)?
> >
> > From my experience the clocks are needed by the timer before any driver
> > initializes.
> >
> >>
> >> In mt6589 pericfg apart from the clocks and reset controller provides
> >> registers for AXI bus control and USB wakeup and USB clock selection.
> >> The infracfg block provides top AXI bus fabric control signals and
> >> remap registers for the modem.
> >> Mike, Stephen, what do you think. Can we implement the clk in a mfd
> >> driver? Or do you prefer to implement the whole block in the clk
> >> driver?
> >
> > Currently the clk support uses regular CLK_OF_DECLARE which handles the
> > clock part of pericfg/infracfg and then later a regular driver for
> > pericfg/infracfg comes and handles the rest of the functionality. Since
> > both use separate registers in the device register space it should work
> > fine.
> 
> It should work until some driver start to use request and map, as you
> provide the whole register space.

Why do you think so? The clock driver continues working after the
pericfg/infracfg drivers have probed.

> If you want to implement drivers for pericfg/infracfg like this, why
> don't you implement the reset controller in drivers/reset?

I want to have a single driver for pericfg/infracfg, the clk support
only bypasses this since it's needed so early. Otherwise I would
register the clocks from the pericfg/infracfg probe function.

BTW in earlier versions we had a syscon binding so that child devices
such as the reset driver could access the registers via regmap. Anyway,
since

bdb0066 mfd: syscon: Decouple syscon interface from platform devices

syscon devices no longer probe by themselves, so we can't put the reset
controller and stuff as child devices under the syscon node anymore.

> 
> Anyway I'm not really happy with the solution of having several device
> drivers for the same dts compatible string.

Me neither, but what do you want to do about it?

Sascha

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |