[PATCH v6 0/2] ARM: hip04: add GPIO support

[Zhou Wang]

Hi Linus, Hi Haojian,

Any comments about this patch?

Best regards,
Zhou Wang

On 2015/1/12 15:05, Zhou Wang wrote:
> This series add the support for the GPIOs of Hisilicon Soc hip04. Hip04 uses
> synopsis' GPIO IP, and we use the dwapb GPIO driver here. This series add the
> corresponding dts. The default value of ARCH_NR_GPIOS is used to find gpio
> base here.
> 
> I resend this patchset with new E-mail address in signed-off-by.
> 
> Change in v6:
> - Change E-mail address in signed-off-by to "wangzhou1 at hisilicon.com"
> Change in v5:
> - Base on v3.19-rc1
> - Just use default value of ARCH_NR_GPIOS to find gpio base. Remove the new
>   added patch(3/4) in v4.
> Change in v4:
> - Delete "default 128 if ARCH_HIP04" in arch/arm/Kconfig
> - add a new patch to support find GPIO base number in increasing order
> - add gpio-number-forward property in snps gpio binding doc
> Change in v3:
> - Move CONFIG_GPIO_DWAPB to hisi_defconfig
> - Add CONFIG_GPIOLIB, CONFIG_GPIO_SYSFS in hisi_defconfig
> Change in v2:
> - Add select GPIO_DWAPB in arch/arm/mach-hisi/Kconfig
> 
> Link for v4:
> - http://www.spinics.net/lists/arm-kernel/msg383883.html
> Link for v3:
> - http://www.spinics.net/lists/devicetree/msg60324.html
> 
> Zhou Wang (2):
>   ARM: hip04: add GPIO configure in hisi_defconfig
>   ARM: dts: hip04: add GPIO pieces
> 
>  arch/arm/boot/dts/hip04.dtsi    | 75 +++++++++++++++++++++++++++++++++++++++++
>  arch/arm/configs/hisi_defconfig |  1 +
>  2 files changed, 76 insertions(+)
>