[PATCH v2 1/3] ASoC: codecs: wm8904: add dt ids table

[Nicolas Ferre]

Le 16/01/2015 02:17, Bo Shen a écrit :
> Hi Mark,
> 
> On 01/15/2015 07:54 PM, Mark Brown wrote:
>> On Mon, Dec 15, 2014 at 11:31:11AM +0800, Bo Shen wrote:
>>
>>> +#ifdef CONFIG_OF
>>> +static enum wm8904_type wm8904_data = WM8904;
>>> +static enum wm8904_type wm8912_data = WM8912;
>>> +
>>> +static const struct of_device_id wm8904_of_match[] = {
>>> +	{
>>> +		.compatible = "wlf,wm8904",
>>> +		.data = &wm8904_data,
>>
>> Does this end up in the i2c_driver_id driver data or do we need some
>> extra code when devtype is assigned to check for an of_node and look at
>> the DT data instead?  That certainly used to be the case...
> 
> At the beginning I think as the same as you, and also add the code to 
> get the data as I do in <drivers/misc/atmel-ssc.c>. However, as I 
> remember, I2C seems only use the compatible string after the comma, that 
> means only for "wlf,wm8904", it uses "wm8904" to match. So, I remove all 
> the code I added, and just keep these, and it can get the device type 
> correctly.
> 
> So, when I submit the patch and keep the code as simple as possible.
> 
> Thanks.
> 
> Best Regards,
> Bo Shen

I don't understand what's keeping this patch from being applied. Voice,
do you mind re-sending?

On my side, I take the two patches that apply on AT91 DT (2/3 and 3/3).

Bye,
-- 
Nicolas Ferre