[GIT PULL 2/3] ARM: imx: device tree changes for 3.20
Shawn Guo
shawn.guo at linaro.org
Fri Jan 23 01:16:43 PST 2015
Hi Arnd, Olof,
Please note this change set depends on imx-soc-3.20, thanks.
Shawn
The following changes since commit c205389557aac828f8403db0368d1fc2ef859213:
ARM: imx: clk-vf610: Add clock for SNVS (2015-01-13 19:16:26 +0800)
are available in the git repository at:
git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux.git tags/imx-dt-3.20
for you to fetch changes up to 16baf8ddd84b36e6880092da777a67de362f8677:
ARM: dts: imx28-evk: remove duplicate property (2015-01-20 19:39:28 +0800)
----------------------------------------------------------------
The i.MX device tree update for 3.20:
- Update i.MX6 operating-points setting in device tree to match the
latest i.MX6 data sheet
- Add i.MX6SX sabreauto board support
- Add imx6dl-udoo board support based off imx6q-udoo
- Update sabrelite board to include I2C and HDMI support
- Update the VPU compatible strings to also use cnm,coda<model>
- Remove the ocram clock from the VPU node, as the clock is already
provided inside the ocram node
- Add system reset controller and syscon-reboot for VF610
- Update VF610 device tree to use zero based naming for GPIO nodes,
so that the number scheme matches hardware manual
- A number of random device additions like watchdog for VF610, sahara
for i.MX53, QSPI for imx6sx-sdb board, etc.
Note: the branch imx/soc was merged into imx/dt because the SNVS device
tree node needs to refer to the new clock ID added by the imx/soc patch.
----------------------------------------------------------------
Anson Huang (3):
ARM: dts: imx6q: update cpufreq volt/freq table
ARM: dts: imx6dl: correct cpufreq volt/freq table
ARM: dts: imx6sx: add i.mx6sx sabreauto board support
Anton Bondarenko (1):
ARM: dts: imx6q: enable dma for ecspi5
Eric Nelson (3):
ARM: dts: sabrelite: add i2c2
ARM: dts: sabrelite: add hdmi
ARM: dts: sabrelite: add i2c3
Fabio Estevam (3):
ARM: dts: imx: Update VPU compatible strings
ARM: dts: imx6qdl: Remove OCRAM clock from VPU node
ARM: dts: imx6sx-sdb: Add QSPI support
Gwenhael Goavec-Merou (1):
ARM: imx: apf51dev: add gpio-backlight support
Michael Heimpold (1):
ARM: dts: imx28-evk: remove duplicate property
Philippe Reynes (1):
apf27dev: add max5821 to the dts
Robert Nelson (1):
ARM: dts: imx6dl-udoo: Add board support based off imx6q-udoo
Sanchayan Maity (1):
ARM: dts: vfxxx: Add SNVS node
Shawn Guo (1):
Merge branch 'imx/soc' into imx/dt
Stefan Agner (4):
ARM: dts: vf610: enable watchdog for Cortex-A5 dt's
ARM: dts: vf-colibri: add CLKOUT pin to pinctrl of FEC1
ARM: dts: vf610: add system reset controller and syscon-reboot
ARM: vf610: use zero based naming for GPIO nodes
Steffen Trumtrar (1):
ARM: i.MX53: dts: add sahara module
arch/arm/boot/dts/Makefile | 2 +
arch/arm/boot/dts/imx27-apf27dev.dts | 21 +++++
arch/arm/boot/dts/imx27.dtsi | 2 +-
arch/arm/boot/dts/imx28-evk.dts | 1 -
arch/arm/boot/dts/imx51-apf51dev.dts | 14 +++
arch/arm/boot/dts/imx53.dtsi | 11 ++-
arch/arm/boot/dts/imx6dl-udoo.dts | 18 ++++
arch/arm/boot/dts/imx6dl.dtsi | 2 +-
arch/arm/boot/dts/imx6q-udoo.dts | 124 +------------------------
arch/arm/boot/dts/imx6q.dtsi | 4 +-
arch/arm/boot/dts/imx6qdl-sabrelite.dtsi | 33 +++++++
arch/arm/boot/dts/imx6qdl-udoo.dtsi | 134 +++++++++++++++++++++++++++
arch/arm/boot/dts/imx6qdl.dtsi | 5 +-
arch/arm/boot/dts/imx6sx-sabreauto.dts | 146 ++++++++++++++++++++++++++++++
arch/arm/boot/dts/imx6sx-sdb.dts | 39 ++++++++
arch/arm/boot/dts/vf-colibri-eval-v3.dtsi | 2 +-
arch/arm/boot/dts/vf-colibri.dtsi | 3 +-
arch/arm/boot/dts/vf500.dtsi | 23 ++++-
arch/arm/boot/dts/vf610-twr.dts | 2 +-
arch/arm/boot/dts/vfxxx.dtsi | 48 +++++++---
20 files changed, 484 insertions(+), 150 deletions(-)
create mode 100644 arch/arm/boot/dts/imx6dl-udoo.dts
create mode 100644 arch/arm/boot/dts/imx6qdl-udoo.dtsi
create mode 100644 arch/arm/boot/dts/imx6sx-sabreauto.dts
More information about the linux-arm-kernel
mailing list