[PATCH v2 4/9] ARM: STi: DT: STiH407: Add Device Tree node for the LPC

[David Paris]

Hi Lee,

     Just a minor remark/question,

     David

On 01/22/2015 12:56 PM, Lee Jones wrote:
> On current ST platforms the LPC controls a number of functions.  This
> patch enables support for the LPC Watchdog and LPC RTC devices on LPC1
> and LPC2 respectively.
>
> Signed-off-by: David Paris <david.paris at st.com>
> Signed-off-by: Lee Jones <lee.jones at linaro.org>
> ---
>   arch/arm/boot/dts/stih407-family.dtsi | 20 ++++++++++++++++++++
>   1 file changed, 20 insertions(+)
>
> diff --git a/arch/arm/boot/dts/stih407-family.dtsi b/arch/arm/boot/dts/stih407-family.dtsi
> index 3e31d32..04448a7 100644
> --- a/arch/arm/boot/dts/stih407-family.dtsi
> +++ b/arch/arm/boot/dts/stih407-family.dtsi
> @@ -7,6 +7,7 @@
>    * publishhed by the Free Software Foundation.
>    */
>   #include "stih407-pinctrl.dtsi"
> +#include <dt-bindings/mfd/st-lpc.h>
>   #include <dt-bindings/reset-controller/stih407-resets.h>
>   / {
>   	#address-cells = <1>;
> @@ -274,5 +275,24 @@
>   
>   			status = "disabled";
>   		};
> +
> +		/* Watchdog and Real-Time Clock */
> +		lpc at 8787000 {
> +			compatible = "st,stih407-lpc";
> +			reg = <0x8787000 0x1000>;
> +			interrupts = <GIC_SPI 129 IRQ_TYPE_EDGE_RISING>;
In case of Watchdog, "interrupt" property is not used. So I think we can 
remove it ?
> +			clocks = <&clk_s_d3_flexgen CLK_LPC_0>;
> +			timeout-sec = <120>;
> +			st,syscfg = <&syscfg_core>;
> +			st,lpc-mode = <ST_LPC_MODE_WDT>;
> +		};
> +
> +		lpc at 8788000 {
> +			compatible = "st,stih407-lpc";
> +			reg = <0x8788000 0x1000>;
> +			interrupts = <GIC_SPI 130 IRQ_TYPE_EDGE_RISING>;
> +			clocks = <&clk_s_d3_flexgen CLK_LPC_1>;
> +			st,lpc-mode = <ST_LPC_MODE_RTC>;
> +		};
>   	};
>   };