[PATCH 2/2] remoteproc: microblaze: Add support for microblaze on Zynq

[Michal Simek]

On 01/22/2015 05:53 PM, Nathan Lynch wrote:
> On 01/19/2015 04:30 AM, Michal Simek wrote:
>> diff --git a/drivers/remoteproc/Kconfig b/drivers/remoteproc/Kconfig
>> index 5e343bab9458..3955f42e9e9c 100644
>> --- a/drivers/remoteproc/Kconfig
>> +++ b/drivers/remoteproc/Kconfig
>> @@ -64,4 +64,15 @@ config DA8XX_REMOTEPROC
>>  	  It's safe to say n here if you're not interested in multimedia
>>  	  offloading.
>>
>> +config MB_REMOTEPROC
>> +	tristate "Support Microblaze remoteproc"
>> +	depends on ARCH_ZYNQ && !DEBUG_SG
>> +	select GPIO_XILINX
>> +	select REMOTEPROC
>> +	select RPMSG
>> +	default m
>> +	help
>> +	  Say y here to support Xilinx Microblaze remote processors
>> +	  on the Xilinx Zynq.
>> +
>>  endmenu
> 
> The dependency on !DEBUG_SG seems unusual, and worth a comment if it's
> truly needed.  And the module should be disabled by default, no?

Right - I will remove this dependency. It is not needed now.

Using is like a module is good usecase because you can reload SW on remote cpu.

Thanks,
Michal