[PATCH net-next v13 3/3] net: hisilicon: new hip04 ethernet driver
Arnd Bergmann
arnd at arndb.de
Tue Jan 20 04:01:53 PST 2015
On Tuesday 20 January 2015 10:15:05 Ding Tianhong wrote:
> On 2015/1/20 4:34, Arnd Bergmann wrote:
> > On Monday 19 January 2015 19:11:11 Alexander Graf wrote:
> >>
> >> After hammering on the box a bit again, I'm in a situation where I get
> >> lots of
> >>
> >> [302398.232603] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302398.377309] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302398.395198] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302398.466118] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302398.659009] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302399.053389] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302399.122067] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302399.268192] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302399.286081] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302399.594201] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302399.683416] hip04-ether e28b0000.ethernet eth0: rx drop
> >> [302399.701307] hip04-ether e28b0000.ethernet eth0: rx drop
> >>
> >> and I really am getting a lot of drops - I can't even ping the machine
> >> anymore.
> >>
> >> However, as it is there's a good chance the machine is simply
> >> unreachable because it's busy writing to the UART, and even if not all
> >> useful messages indicating anything have scrolled out. I really don't
> >> think you should emit any message over and over again to the user. Once
> >> or twice is enough.
> >>
> >> Please make sure to rate limit it.
> >
> > I would argue that packet loss is not an error condition at all
> > and you should not print this at netdev_err() level. You could make
> > this a netdev_dbg(), or just make it silent because it's already
> > counted in the statistics.
> >
>
> I think something wrong with Graf's board, I will try to make it happen on my board, and
> in any case I will add rate limit to xx_drop and change to dbg log level.
I've looked at the interrupt handling in more detail and came up
with this patch. Please review, and forward if you are happy with the
changes.
Alex, could you try if this solves your problem?
8<----
Subject: [PATCH] net/hip04: refactor interrupt masking
The hip04 ethernet driver currently acknowledges all interrupts directly
in the interrupt handler, and leaves all interrupts except the RX data
enabled the whole time. This causes multiple problems:
- When more packets come in between the original interrupt and the
NAPI poll function, we will get an extraneous RX interrupt as soon
as interrupts are enabled again.
- The two error interrupts are by definition combining all errors that
may have happened since the last time they were handled, but just
acknowledging the irq without dealing with the cause of the condition
makes it come back immediately. In particular, when NAPI is intentionally
stalling the rx queue, this causes a storm of "rx dropped" messages.
- The access to the 'reg_inten' field in hip_priv is used for serializing
access, but is in fact racy itself.
To deal with these issues, the driver is changed to only acknowledge
the IRQ at the point when it is being handled. The RX interrupts now get
acked right before reading the number of received frames to keep spurious
interrupts to the absolute minimum without losing interrupts.
As there is no tx-complete interrupt, only an informational tx-dropped
one, we now ack that in the tx reclaim handler, hoping that clearing
the descriptors has also eliminated the error condition.
The only place that reads the reg_inten now just relies on
napi_schedule_prep() to return whether NAPI is active or not, and
the poll() function is then going to ack and reenabled the IRQ if
necessary.
Finally, when we disable interrupts, they are now all disabled
together, in order to simplify the logic and to avoid getting
rx-dropped interrupts when NAPI is in control of the rx queue.
Signed-off-by: Arnd Bergmann <arnd at arndb.de>
diff --git a/drivers/net/ethernet/hisilicon/hip04_eth.c b/drivers/net/ethernet/hisilicon/hip04_eth.c
index 525214ef5984..83773247a368 100644
--- a/drivers/net/ethernet/hisilicon/hip04_eth.c
+++ b/drivers/net/ethernet/hisilicon/hip04_eth.c
@@ -56,6 +56,8 @@
#define RCV_DROP BIT(7)
#define TX_DROP BIT(6)
#define DEF_INT_ERR (RCV_NOBUF | RCV_DROP | TX_DROP)
+#define DEF_INT_RX (RCV_INT | RCV_NOBUF | RCV_DROP)
+#define DEF_INT_TX (TX_DROP)
#define DEF_INT_MASK (RCV_INT | DEF_INT_ERR)
/* TX descriptor config */
@@ -154,7 +156,6 @@ struct hip04_priv {
unsigned int port;
unsigned int speed;
unsigned int duplex;
- unsigned int reg_inten;
struct napi_struct napi;
struct net_device *ndev;
@@ -303,17 +304,15 @@ static void hip04_mac_enable(struct net_device *ndev)
val |= GE_RX_PORT_EN | GE_TX_PORT_EN;
writel_relaxed(val, priv->base + GE_PORT_EN);
- /* clear rx int */
- val = RCV_INT;
- writel_relaxed(val, priv->base + PPE_RINT);
+ /* clear prior interrupts */
+ writel_relaxed(DEF_INT_MASK, priv->base + PPE_RINT);
/* config recv int */
val = GE_RX_INT_THRESHOLD | GE_RX_TIMEOUT;
writel_relaxed(val, priv->base + PPE_CFG_RX_PKT_INT);
/* enable interrupt */
- priv->reg_inten = DEF_INT_MASK;
- writel_relaxed(priv->reg_inten, priv->base + PPE_INTEN);
+ writel_relaxed(DEF_INT_MASK, priv->base + PPE_INTEN);
}
static void hip04_mac_disable(struct net_device *ndev)
@@ -322,8 +321,7 @@ static void hip04_mac_disable(struct net_device *ndev)
u32 val;
/* disable int */
- priv->reg_inten &= ~(DEF_INT_MASK);
- writel_relaxed(priv->reg_inten, priv->base + PPE_INTEN);
+ writel_relaxed(0, priv->base + PPE_INTEN);
/* disable tx & rx */
val = readl_relaxed(priv->base + GE_PORT_EN);
@@ -403,6 +401,8 @@ static int hip04_tx_reclaim(struct net_device *ndev, bool force)
priv->tx_tail = tx_tail;
smp_wmb(); /* Ensure tx_tail visible to xmit */
+ writel_relaxed(DEF_INT_TX, priv->base + PPE_RINT);
+
out:
if (pkts_compl || bytes_compl)
netdev_completed_queue(ndev, pkts_compl, bytes_compl);
@@ -458,9 +458,7 @@ static int hip04_mac_start_xmit(struct sk_buff *skb, struct net_device *ndev)
if (count >= priv->tx_coalesce_frames) {
if (napi_schedule_prep(&priv->napi)) {
/* disable rx interrupt and timer */
- priv->reg_inten &= ~(RCV_INT);
- writel_relaxed(DEF_INT_MASK & ~RCV_INT,
- priv->base + PPE_INTEN);
+ writel_relaxed(0, priv->base + PPE_INTEN);
hrtimer_cancel(&priv->tx_coalesce_timer);
__napi_schedule(&priv->napi);
}
@@ -478,7 +476,7 @@ static int hip04_rx_poll(struct napi_struct *napi, int budget)
struct hip04_priv *priv = container_of(napi, struct hip04_priv, napi);
struct net_device *ndev = priv->ndev;
struct net_device_stats *stats = &ndev->stats;
- unsigned int cnt = hip04_recv_cnt(priv);
+ unsigned int cnt;
struct rx_desc *desc;
struct sk_buff *skb;
unsigned char *buf;
@@ -489,6 +487,10 @@ static int hip04_rx_poll(struct napi_struct *napi, int budget)
u16 len;
u32 err;
+ /* acknowledge interrupts and read status */
+ writel_relaxed(DEF_INT_RX, priv->base + PPE_RINT);
+ cnt = hip04_recv_cnt(priv);
+
while (cnt && !last) {
buf = priv->rx_buf[priv->rx_head];
skb = build_skb(buf, priv->rx_buf_size);
@@ -539,11 +541,8 @@ static int hip04_rx_poll(struct napi_struct *napi, int budget)
cnt = hip04_recv_cnt(priv);
}
- if (!(priv->reg_inten & RCV_INT)) {
- /* enable rx interrupt */
- priv->reg_inten |= RCV_INT;
- writel_relaxed(priv->reg_inten, priv->base + PPE_INTEN);
- }
+ /* enable rx interrupt */
+ writel_relaxed(DEF_INT_MASK, priv->base + PPE_INTEN);
napi_complete(napi);
done:
/* clean up tx descriptors and start a new timer if necessary */
@@ -564,23 +563,21 @@ static irqreturn_t hip04_mac_interrupt(int irq, void *dev_id)
if (!ists)
return IRQ_NONE;
- writel_relaxed(DEF_INT_MASK, priv->base + PPE_RINT);
-
if (unlikely(ists & DEF_INT_ERR)) {
- if (ists & (RCV_NOBUF | RCV_DROP))
+ if (ists & (RCV_NOBUF | RCV_DROP)) {
stats->rx_errors++;
stats->rx_dropped++;
- netdev_err(ndev, "rx drop\n");
+ netdev_dbg(ndev, "rx drop\n");
+ }
if (ists & TX_DROP) {
stats->tx_dropped++;
- netdev_err(ndev, "tx drop\n");
+ netdev_dbg(ndev, "tx drop\n");
}
}
- if (ists & RCV_INT && napi_schedule_prep(&priv->napi)) {
- /* disable rx interrupt */
- priv->reg_inten &= ~(RCV_INT);
- writel_relaxed(DEF_INT_MASK & ~RCV_INT, priv->base + PPE_INTEN);
+ if (napi_schedule_prep(&priv->napi)) {
+ /* disable interrupt */
+ writel_relaxed(0, priv->base + PPE_INTEN);
hrtimer_cancel(&priv->tx_coalesce_timer);
__napi_schedule(&priv->napi);
}
@@ -596,8 +593,7 @@ enum hrtimer_restart tx_done(struct hrtimer *hrtimer)
if (napi_schedule_prep(&priv->napi)) {
/* disable rx interrupt */
- priv->reg_inten &= ~(RCV_INT);
- writel_relaxed(DEF_INT_MASK & ~RCV_INT, priv->base + PPE_INTEN);
+ writel_relaxed(0, priv->base + PPE_INTEN);
__napi_schedule(&priv->napi);
}
More information about the linux-arm-kernel
mailing list