[PATCH 16/17] ARM: shmobile: kzm9g dts: Move Ethernet node to BSC

[Simon Horman]

From: Geert Uytterhoeven <geert+renesas at glider.be>

Move the Ethernet node from the root of the device tree to the BSC node,
as it's connected to the Bus State Controller.  This allows the system
to know the right position of the Ethernet node in the clock and PM
domain hierarchy, and manage the clock and PM domain appropriately.

Also rename the node's name from "lan9220" to "ethernet", to conform to
ePAPR generic name recomendations.

Signed-off-by: Geert Uytterhoeven <geert+renesas at glider.be>
Signed-off-by: Simon Horman <horms+renesas at verge.net.au>
---
 arch/arm/boot/dts/sh73a0-kzm9g.dts | 28 +++++++++++++++-------------
 1 file changed, 15 insertions(+), 13 deletions(-)

diff --git a/arch/arm/boot/dts/sh73a0-kzm9g.dts b/arch/arm/boot/dts/sh73a0-kzm9g.dts
index 6f00e6b..022ba50 100644
--- a/arch/arm/boot/dts/sh73a0-kzm9g.dts
+++ b/arch/arm/boot/dts/sh73a0-kzm9g.dts
@@ -84,19 +84,6 @@
 		enable-active-high;
 	};
 
-	lan9220 at 10000000 {
-		compatible = "smsc,lan9220", "smsc,lan9115";
-		reg = <0x10000000 0x100>;
-		phy-mode = "mii";
-		interrupt-parent = <&irqpin0>;
-		interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
-		reg-io-width = <4>;
-		smsc,irq-push-pull;
-		smsc,save-mac-address;
-		vddvario-supply = <&reg_1p8v>;
-		vdd33a-supply = <&reg_3p3v>;
-	};
-
 	leds {
 		compatible = "gpio-leds";
 		led1 {
@@ -178,6 +165,21 @@
 	};
 };
 
+&bsc {
+	ethernet at 10000000 {
+		compatible = "smsc,lan9220", "smsc,lan9115";
+		reg = <0x10000000 0x100>;
+		phy-mode = "mii";
+		interrupt-parent = <&irqpin0>;
+		interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
+		reg-io-width = <4>;
+		smsc,irq-push-pull;
+		smsc,save-mac-address;
+		vddvario-supply = <&reg_1p8v>;
+		vdd33a-supply = <&reg_3p3v>;
+	};
+};
+
 &cmt1 {
 	status = "okay";
 };
-- 
2.1.4