[PATCH 1/3] ARM: dts: exynos4412-trats2: Add Maxim 77693 fuel gauge node

Krzysztof Kozlowski k.kozlowski at samsung.com
Thu Jan 15 00:41:33 PST 2015


Add node for fuel gauge present in Maxim 77693 PMIC. This allows control
over battery charging state on Trats2 board.

The fuel gauge is compatible with max17042 battery driver (Maxim
17042/17047/17050).  Although datasheet rev 2.2 for MAX77693 describes
fuel gauge as Maxim 17042-like, the chip on Trats2 board identifies
itself as Maxim 17047-like.

Signed-off-by: Krzysztof Kozlowski <k.kozlowski at samsung.com>
---
 arch/arm/boot/dts/exynos4412-trats2.dts | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)

diff --git a/arch/arm/boot/dts/exynos4412-trats2.dts b/arch/arm/boot/dts/exynos4412-trats2.dts
index 29231b452643..595ad4ba6977 100644
--- a/arch/arm/boot/dts/exynos4412-trats2.dts
+++ b/arch/arm/boot/dts/exynos4412-trats2.dts
@@ -15,6 +15,7 @@
 /dts-v1/;
 #include "exynos4412.dtsi"
 #include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/interrupt-controller/irq.h>
 
 / {
 	model = "Samsung Trats 2 based on Exynos4412";
@@ -24,6 +25,7 @@
 		i2c9 = &i2c_ak8975;
 		i2c10 = &i2c_cm36651;
 		i2c11 = &i2c_max77693;
+		i2c12 = &i2c_max77693_fuel;
 	};
 
 	memory {
@@ -552,6 +554,22 @@
 		};
 	};
 
+	i2c_max77693_fuel: i2c-gpio-3 {
+		compatible = "i2c-gpio";
+		gpios = <&gpf1 5 GPIO_ACTIVE_HIGH>, <&gpf1 4 GPIO_ACTIVE_HIGH>;
+		i2c-gpio,delay-us = <2>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+		status = "okay";
+
+		max77693-fuel-gauge at 36 {
+			compatible = "maxim,max17047";
+			interrupt-parent = <&gpx2>;
+			interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
+			reg = <0x36>;
+		};
+	};
+
 	mmc at 12550000 {
 		num-slots = <1>;
 		broken-cd;
-- 
1.9.1




More information about the linux-arm-kernel mailing list