[PATCH v2 1/5] rtc: armada38x: Add the device tree binding documentation

[Gregory CLEMENT]

Hi Thomas,

On 14/01/2015 20:22, Thomas Petazzoni wrote:
> Dear Gregory CLEMENT,
> 
> On Wed, 14 Jan 2015 18:39:11 +0100, Gregory CLEMENT wrote:
> 
>> +Required properties:
>> +- compatible : Should be "marvell,armada-380-rtc"
>> +- reg: physical base address of the controller and length of memory
>> +  mapped region, associated to the reg-name "rtc". The other entry is
>> +  related to the interrupt control from the SoC, associated to the
>> +  reg-name "soc-interrupt".
> 
> soc-interrupt or...

I changed all the name from soc-interrupt to soc-int except here.
I will fix it.

> 
>> +- reg-names: names of the mapped memory regions listed in regs
>> +    property in the same order: "rtc" and "soc-int".
> 
> soc-int ?
> 
>> +rtc at a3800 {
>> +	compatible = "marvell,armada-380-rtc";
>> +	reg = <0xa3800 0x20>, <0x184a0 0x0c>;
> 
> Any reason to use <0x184A0 0xC> instead of <0x184A8 0x4> ? According to
> the datasheet, there is only this 184A8 register for RTC stuff.

Yes but according to the code I saw there were other registers related to the RTC
from 0x184A0. Even if we don't use them now I prefer having an accurate mapping from
the beginning for avoiding using negative offset as we needed to do in the past.

Thanks,

Gregory


-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com