[RFC PATCH v2 2/4] serial: mxs-auart: Use helpers for gpio irqs

[Janusz Użycki]

W dniu 2015-01-13 o 09:08, Uwe Kleine-König pisze:
> Hello,
>
> On Sat, Jan 10, 2015 at 03:32:44PM +0100, Janusz Uzycki wrote:
>> The patch updates mxs-auart driver to use new mctrl_gpio helpers for
>> gpio irqs. The code is much simpler now.
>>
>> Signed-off-by: Janusz Uzycki <j.uzycki at elproma.com.pl>
>> ---
>>
>> There is no changes since v1 (rebased only).
>>
>> ---
>>   drivers/tty/serial/mxs-auart.c | 133 ++++-------------------------------------
>>   1 file changed, 13 insertions(+), 120 deletions(-)
> Very nice!
>
>> diff --git a/drivers/tty/serial/mxs-auart.c b/drivers/tty/serial/mxs-auart.c
>> index ec553f8..2ddba69 100644
>> --- a/drivers/tty/serial/mxs-auart.c
>> +++ b/drivers/tty/serial/mxs-auart.c
>> [...]
>> @@ -483,18 +458,9 @@ static void mxs_auart_enable_ms(struct uart_port *port)
>>   
>>   	s->ms_irq_enabled = true;
>>   
>> -	if (s->gpio_irq[UART_GPIO_CTS] >= 0)
>> -		enable_irq(s->gpio_irq[UART_GPIO_CTS]);
>> -	/* TODO: enable AUART_INTR_CTSMIEN otherwise */
>> -
>> -	if (s->gpio_irq[UART_GPIO_DSR] >= 0)
>> -		enable_irq(s->gpio_irq[UART_GPIO_DSR]);
>> -
>> -	if (s->gpio_irq[UART_GPIO_RI] >= 0)
>> -		enable_irq(s->gpio_irq[UART_GPIO_RI]);
>> -
>> -	if (s->gpio_irq[UART_GPIO_DCD] >= 0)
>> -		enable_irq(s->gpio_irq[UART_GPIO_DCD]);
>> +	mctrl_gpio_enable_ms(s->gpios);
>> +	/* TODO: enable AUART_INTR_CTSMIEN
>> +	 * if s->gpios->irq[UART_GPIO_CTS] == 0 */
> What is the problem here? For the other lines nothing needs to be done?
> This comment doesn't match the coding style.

Right, the comment should be rather:
/* TODO: enable AUART_INTR_CTSMIEN
  * if (!mctrl_gpio_is_gpio(atmel_port->gpios, UART_GPIO_CTS)) */

In this place I marked that CTSMIEN should be switched on 
enable/disable_ms if CTS
is not a gpio. The driver enables CTSMIEN forever what is wrong but I 
can't test it
and I don't need it so I've just marked the fact in the comment.

>
> Other than that, this patch looks good.
>
> Uwe
>

Thanks
Janusz