[PATCH v3 00/19] Exynos SYSMMU (IOMMU) integration with DT and DMA-mapping subsystem
Joonyoung Shim
jy0922.shim at samsung.com
Tue Jan 13 00:40:01 PST 2015
On 01/13/2015 02:24 PM, Joonyoung Shim wrote:
> Hi,
>
> On 01/13/2015 01:09 AM, Javier Martinez Canillas wrote:
>> Hello Joonyoung,
>>
>> On 01/12/2015 07:40 AM, Joonyoung Shim wrote:
>>>> And also making changes to the clocks in the clk-exynos5420 driver. Can
>>>> you please explain the rationale for those changes? I'm asking because
>>>> without your clock changes (only adding the DISP1 pd and making the
>>>> devices as consumers), I've HDMI output too but video is even worse. This
>>>> [0] is the minimal change I have on top of 3.19-rc3 to have some output.
>>>>
>>>
>>> I just refer below patches,
>>> http://comments.gmane.org/gmane.linux.kernel.samsung-soc/34576
>>>
>>> But i'm not sure whether DISP1 power domain is same case with MFC power domain.
>>>
>>
>> Thanks a lot for sharing those patches, now your changes are much more
>> clear to me.
>>
>>>>
>>>> So there seems to be two issues here, one is the mixer and hdmi modules not
>>>> being attached to the DISP1 power domain and another one is the clocks setup
>>>> not being correct to have proper HDMI video output.
>>>>
>>>
>>> Hmm, i can see normal hdmi output still from latest upstream
>>> kernel(3.19-rc4) with my kernel changes and u-boot changes(DISP1 power
>>> domain disable) of prior mail on odroid xu3 board.
>>>
>>
>> I thought you said on another email that after commit 2ed127697eb1 which
>> landed on 3.19-rc1 you had bad HDMI output?
>>
>> In your changes, it was missing the SW_ACLK_400_DISP1 and USER_ACLK_400_DISP1
>> clock mux outputs that goes to internal buses in the DISP1. Adding IDs for
>> these in the exynos5420 clock driver and to the parent and input clock paris
>> list in the DISP1 power domain gives me a good HDMI output on 3.19-rc2.
>>
>> Also, the SW_ACLK_300_DISP1 and USER_ACLK_300_DISP1 are needed for the FIMD
>> parent and input clock respectively. Adding those to the clocks list of the
>> DISP1 power domain gives me working display + HDMI on my Exynos5800 Peach Pi.
>>
>> These are the changes I have now [0]. Please let me know what you think.
>>
>
> Good, it's working with your patch without u-boot changes and reverting
> of commit 2ed127697eb.
>
But i also get stripe hdmi output if hdmi/mixer drivers aren't defered
probed, because DISP1 power domain isn't disabled on booting by defered
probe so is always on.
Thanks.
More information about the linux-arm-kernel
mailing list