[Patch v2 2/2] dt/bindings: qcom_adm: Fix channel specificers
Andy Gross
agross at codeaurora.org
Wed Jan 7 19:26:12 PST 2015
This patch removes the crci information from the dma channel property. At least
one client device requires using more than one CRCI value for a channel. This
does not match the current binding and the crci information needs to be removed.
Instead, the client device will provide this information via other means.
Signed-off-by: Andy Gross <agross at codeaurora.org>
---
Documentation/devicetree/bindings/dma/qcom_adm.txt | 14 +++++---------
1 file changed, 5 insertions(+), 9 deletions(-)
diff --git a/Documentation/devicetree/bindings/dma/qcom_adm.txt b/Documentation/devicetree/bindings/dma/qcom_adm.txt
index 9bcab91..fba67c6 100644
--- a/Documentation/devicetree/bindings/dma/qcom_adm.txt
+++ b/Documentation/devicetree/bindings/dma/qcom_adm.txt
@@ -4,8 +4,7 @@ Required properties:
- compatible: must contain "qcom,adm" for IPQ/APQ8064 and MSM8960
- reg: Address range for DMA registers
- interrupts: Should contain one interrupt shared by all channels
-- #dma-cells: must be <2>. First cell denotes the channel number. Second cell
- denotes CRCI (client rate control interface) flow control assignment.
+- #dma-cells: must be <1>. First cell denotes the channel number.
- clocks: Should contain the core clock and interface clock.
- clock-names: Must contain "core" for the core clock and "iface" for the
interface clock.
@@ -22,7 +21,7 @@ Example:
compatible = "qcom,adm";
reg = <0x18300000 0x100000>;
interrupts = <0 170 0>;
- #dma-cells = <2>;
+ #dma-cells = <1>;
clocks = <&gcc ADM0_CLK>, <&gcc ADM0_PBUS_CLK>;
clock-names = "core", "iface";
@@ -35,15 +34,12 @@ Example:
qcom,ee = <0>;
};
-DMA clients must use the format descripted in the dma.txt file, using a three
+DMA clients must use the format descripted in the dma.txt file, using a two
cell specifier for each channel.
Each dmas request consists of 3 cells:
1. phandle pointing to the DMA controller
2. channel number
- 3. CRCI assignment, if applicable. If no CRCI flow control is required, use 0.
- The CRCI is used for flow control. It identifies the peripheral device that
- is the source/destination for the transferred data.
Example:
@@ -56,7 +52,7 @@ Example:
cs-gpios = <&qcom_pinmux 20 0>;
- dmas = <&adm_dma 6 9>,
- <&adm_dma 5 10>;
+ dmas = <&adm_dma 6>,
+ <&adm_dma 5>;
dma-names = "rx", "tx";
};
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation
More information about the linux-arm-kernel
mailing list