[PATCH] spi: orion: Add multiple chip select support for Armada 370 and 375

[Gregory CLEMENT]

Hi Ken,

On 06/01/2015 22:30, Ken Wilson wrote:
> Create a new dt binding for the Armada 375 that supports up to
> 3 chip selects but uses the same prescaler values and algorithm
> as the basic orion binding.

There was already a patch that have been sent for this:
http://thread.gmane.org/gmane.linux.kernel.spi.devel/17808/focus=17809

but in the end it has not been merged. The last email on the thread was
about doing the manipulation in set_cs and not in setup_transfer(). And I
didn't find a newer version.

Maybe it just fell through the cracks.
Thomas did you remember of it?

Gregory

> 
> Update the Armada 370 so that it supports up to 4 chip selects.
> 
> This has been tested on the Armada 375 with multiple SPI-NOR chips.
> 
> Signed-off-by: Ken Wilson <ken.wilson at opengear.com>
> ---
>  .../devicetree/bindings/spi/spi-orion.txt          |  3 ++-
>  arch/arm/boot/dts/armada-375.dtsi                  |  4 +--
>  drivers/spi/spi-orion.c                            | 29 +++++++++++++++++++---
>  3 files changed, 29 insertions(+), 7 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/spi/spi-orion.txt b/Documentation/devicetree/bindings/spi/spi-orion.txt
> index 50c3a3d..2aeeb85 100644
> --- a/Documentation/devicetree/bindings/spi/spi-orion.txt
> +++ b/Documentation/devicetree/bindings/spi/spi-orion.txt
> @@ -1,7 +1,8 @@
>  Marvell Orion SPI device
>  
>  Required properties:
> -- compatible : should be "marvell,orion-spi" or "marvell,armada-370-spi".
> +- compatible : should be "marvell,orion-spi", "marvell,armada-370-spi",
> +	or "marvell,armada-375-spi".
>  - reg : offset and length of the register set for the device
>  - cell-index : Which of multiple SPI controllers is this.
>  Optional properties:
> diff --git a/arch/arm/boot/dts/armada-375.dtsi b/arch/arm/boot/dts/armada-375.dtsi
> index de65714..f7a5ce2 100644
> --- a/arch/arm/boot/dts/armada-375.dtsi
> +++ b/arch/arm/boot/dts/armada-375.dtsi
> @@ -192,7 +192,7 @@
>  			};
>  
>  			spi0: spi at 10600 {
> -				compatible = "marvell,orion-spi";
> +				compatible = "marvell,armada-375-spi", "marvell,orion-spi";
>  				reg = <0x10600 0x50>;
>  				#address-cells = <1>;
>  				#size-cells = <0>;
> @@ -203,7 +203,7 @@
>  			};
>  
>  			spi1: spi at 10680 {
> -				compatible = "marvell,orion-spi";
> +				compatible = "marvell,armada-375-spi", "marvell,orion-spi";
>  				reg = <0x10680 0x50>;
>  				#address-cells = <1>;
>  				#size-cells = <0>;
> diff --git a/drivers/spi/spi-orion.c b/drivers/spi/spi-orion.c
> index c76b7d7..4129c37 100644
> --- a/drivers/spi/spi-orion.c
> +++ b/drivers/spi/spi-orion.c
> @@ -28,7 +28,6 @@
>  /* Runtime PM autosuspend timeout: PM is fairly light on this driver */
>  #define SPI_AUTOSUSPEND_TIMEOUT		200
>  
> -#define ORION_NUM_CHIPSELECTS		1 /* only one slave is supported*/
>  #define ORION_SPI_WAIT_RDY_MAX_LOOP	2000 /* in usec */
>  
>  #define ORION_SPI_IF_CTRL_REG		0x00
> @@ -44,6 +43,7 @@
>  #define ARMADA_SPI_CLK_PRESCALE_MASK	0xDF
>  #define ORION_SPI_MODE_MASK		(ORION_SPI_MODE_CPOL | \
>  					 ORION_SPI_MODE_CPHA)
> +#define ORION_SPI_CS_MASK	0x1C
>  
>  enum orion_spi_type {
>  	ORION_SPI,
> @@ -55,6 +55,7 @@ struct orion_spi_dev {
>  	unsigned int		min_divisor;
>  	unsigned int		max_divisor;
>  	u32			prescale_mask;
> +	u8			num_cs;
>  };
>  
>  struct orion_spi {
> @@ -201,6 +202,13 @@ orion_spi_setup_transfer(struct spi_device *spi, struct spi_transfer *t)
>  
>  	orion_spi_mode_set(spi);
>  
> +	if (orion_spi->master->num_chipselect > 1) {
> +		orion_spi_clrbits(orion_spi, ORION_SPI_IF_CTRL_REG,
> +				ORION_SPI_CS_MASK);
> +		orion_spi_setbits(orion_spi, ORION_SPI_IF_CTRL_REG,
> +				(spi->chip_select) << 2);
> +	}
> +
>  	rc = orion_spi_baudrate_set(spi, speed);
>  	if (rc)
>  		return rc;
> @@ -398,18 +406,31 @@ static const struct orion_spi_dev orion_spi_dev_data = {
>  	.min_divisor = 4,
>  	.max_divisor = 30,
>  	.prescale_mask = ORION_SPI_CLK_PRESCALE_MASK,
> +	.num_cs = 1,
>  };
>  
> -static const struct orion_spi_dev armada_spi_dev_data = {
> +static const struct orion_spi_dev armada_370_spi_dev_data = {
>  	.typ = ARMADA_SPI,
>  	.min_divisor = 1,
>  	.max_divisor = 1920,
>  	.prescale_mask = ARMADA_SPI_CLK_PRESCALE_MASK,
> +	.num_cs = 4,
> +};
> +
> +static const struct orion_spi_dev armada_375_spi_dev_data = {
> +	.typ = ORION_SPI,
> +	.min_divisor = 4,
> +	.max_divisor = 30,
> +	.prescale_mask = ORION_SPI_CLK_PRESCALE_MASK,
> +	.num_cs = 3,
>  };
>  
>  static const struct of_device_id orion_spi_of_match_table[] = {
>  	{ .compatible = "marvell,orion-spi", .data = &orion_spi_dev_data, },
> -	{ .compatible = "marvell,armada-370-spi", .data = &armada_spi_dev_data, },
> +	{ .compatible = "marvell,armada-370-spi",
> +		.data = &armada_370_spi_dev_data, },
> +	{ .compatible = "marvell,armada-375-spi",
> +		.data = &armada_375_spi_dev_data, },
>  	{}
>  };
>  MODULE_DEVICE_TABLE(of, orion_spi_of_match_table);
> @@ -444,7 +465,6 @@ static int orion_spi_probe(struct platform_device *pdev)
>  	master->mode_bits = SPI_CPHA | SPI_CPOL;
>  
>  	master->transfer_one_message = orion_spi_transfer_one_message;
> -	master->num_chipselect = ORION_NUM_CHIPSELECTS;
>  	master->bits_per_word_mask = SPI_BPW_MASK(8) | SPI_BPW_MASK(16);
>  	master->auto_runtime_pm = true;
>  
> @@ -470,6 +490,7 @@ static int orion_spi_probe(struct platform_device *pdev)
>  	tclk_hz = clk_get_rate(spi->clk);
>  	master->max_speed_hz = DIV_ROUND_UP(tclk_hz, devdata->min_divisor);
>  	master->min_speed_hz = DIV_ROUND_UP(tclk_hz, devdata->max_divisor);
> +	master->num_chipselect = devdata->num_cs;
>  
>  	r = platform_get_resource(pdev, IORESOURCE_MEM, 0);
>  	spi->base = devm_ioremap_resource(&pdev->dev, r);
> 


-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com