[PATCH 0/8] Add proper support for Compulab CM-A510/SBC-A510

[Stephen Warren]

On 02/26/2015 12:39 PM, Sebastian Hesselbarth wrote:
> On 26.02.2015 18:55, Gregory CLEMENT wrote:
>> On 17/02/2015 19:52, Sebastian Hesselbarth wrote:
>>> This patch set improves current mainline support for the Compulab
>>> CM-A510 System-on-Module (SoM) and its default Compulab SBC-A510
>>> base board. Thanks to Gabriel Dobato who agreed to remote debug and
>>> test the provided DT changes.
> [...]
>>> Sebastian Hesselbarth (8):
>>>    i2c: mux-pinctrl: Rework to honor disabled child nodes
>>>    devicetree: vendor-prefixes: Add CompuLab to known vendors
>>>    ARM: dts: dove: Fix uart[23] reg property
>>>    ARM: dts: dove: Always include gpio and interrupt-controller headers
>>>    ARM: dts: dove: Add node labels for PCIe ports 0 and 1
>>>    ARM: dts: dove: Add some more common pinctrl settings
>>>    ARM: dts: dove: Add internal i2c multiplexer node
>>>    ARM: dts: dove: Add proper support for Compulab CM-A510/SBC-A510
>>
>> Patches 3 to 6 applied on mvebu/dt
>>
>> If I understood well patches 7 and 8 depend on patch 1 which had not been
>> taken yet.
>
> Correct. Once I get a Tested-by from Stephen, I'll resend the 4
> remaining patches.

Me? For which patch? I thought there was going to be a v2 of the i2c mux 
driver patch given the comments on it, but perhaps I'm misremembering?