[PATCH v2 2/2] hwrng: iproc-rng200 - Add Broadcom IPROC RNG driver

[Scott Branden]

Response inline.

On 15-02-25 11:17 AM, Arnd Bergmann wrote:
> On Wednesday 25 February 2015 10:16:24 Scott Branden wrote:
>> This adds a driver for random number generator present on Broadcom
>> IPROC devices.
>>
>> Reviewed-by: Ray Jui <rjui at broadcom.com>
>> Signed-off-by: Scott Branden <sbranden at broadcom.com>
>
> The driver looks reasonable overall, I have just one question about
> something that sticks out:
>
>> +	while ((num_remaining > 0) && time_before(jiffies, idle_endtime)) {
> ...
>> +
>> +		/* Are there any random numbers available? */
>> +		if ((ioread32(rng_base + RNG_FIFO_COUNT_OFFSET) &
>> +				RNG_FIFO_COUNT_RNG_FIFO_COUNT_MASK) > 0) {
> ...
>> +		} else {
>> +			if (!wait)
>> +				/* Cannot wait, return immediately */
>> +				return max - num_remaining;
>> +
>> +			/* Can wait, give others chance to run */
>> +			cpu_relax();
>> +		}
>> +	}
>> +
>
> It looks like you do a busy-loop around cpu_relax here if asked to wait.
> Is this intentional? I would normally expect either cond_resched() or
> some msleep() instead.

This code was following examples of other open source drivers - bcm2835 
and exynos both use cpu_relax.  I'll have to look into this more to 
understand.

>
> 	Arnd
>