[PATCH 1/5] tty/serial: at91: correct check of buf used in DMA

[Jiri Slaby]

On 02/26/2015, 07:55 AM, Leilei Zhao wrote:
> We only use buf of ring In DMA rx function while using buf of xmit
> in DMA tx function. So here we need definitively to check the buf
> of ring which is corresponding to DMA rx function.
> 
> Signed-off-by: Leilei Zhao <leilei.zhao at atmel.com>
> Acked-by: Nicolas Ferre <nicolas.ferre at atmel.com>
> ---
>  drivers/tty/serial/atmel_serial.c |    2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
> index 846552b..460903c 100644
> --- a/drivers/tty/serial/atmel_serial.c
> +++ b/drivers/tty/serial/atmel_serial.c
> @@ -1027,7 +1027,7 @@ static int atmel_prepare_rx_dma(struct uart_port *port)
>  	spin_lock_init(&atmel_port->lock_rx);
>  	sg_init_table(&atmel_port->sg_rx, 1);
>  	/* UART circular rx buffer is an aligned page. */
> -	BUG_ON((int)port->state->xmit.buf & ~PAGE_MASK);
> +	BUG_ON((int)ring->buf & ~PAGE_MASK);

Please use PAGE_ALIGNED. This will also make the bad (int) cast to dismiss.

thanks,
-- 
js
suse labs