[PATCH 2/2] rockchip: efuse: add efuse driver for rk3288 efuse
Heiko Stübner
heiko at sntech.de
Wed Feb 25 15:35:02 PST 2015
Hi Jianqun,
Am Dienstag, 2. Dezember 2014, 23:04:57 schrieb Jianqun:
> 在 12/01/2014 10:10 PM, Heiko Stübner 写道:
> > Am Montag, 1. Dezember 2014, 15:34:41 schrieb Jianqun Xu:
> >> Add driver for efuse found on rk3288 board based on rk3288 SoC.
> >> Driver will read fuse information of chip at the boot stage of
> >> kernel, this information new is for further usage.
> >>
> >> Signed-off-by: Jianqun Xu <jay.xu at rock-chips.com>
> >
> > General question would be, what is the purpose of this driver?
>
> This driver will get efuse information, and other module will use it for
> some useage, such as dvfs will ajust OPP according to the differences
> between chips, that can make chips run on a powersave status
>
> Also can get the chip version... but this patch only show a part feathur
just because I noticed this today, there seems to be an eeprom [0] and efuse
[1] framework in the works. And as the mail from Maxime [2] suggests, both
should probably merge.
So the rockchip efuse driver should probably the framework that will become of
those two.
Heiko
[0] https://lkml.org/lkml/2015/2/19/307
[1] https://lkml.org/lkml/2015/2/25/173
[2] https://lkml.org/lkml/2015/2/25/191
> > I don't see any publically usable functions and the only thing happening
> > is
> > the
> >
> > dev_info(efuse->dev, "leakage (%d %d %d)\n",...
> >
> > output that emits some information from the efuse to the kernel log?
>
> can I make it a node under some debug directory ? For now only show it in
> boot message.
> > In the dt-binding doc you write:
> >> The 32x32 eFuse can only be accessed by APB bus when IO_SECURITYsel is
> >> high.>
> > While the TRM also says this, IO_SECURITY is not mentioned anywhere else
> > in
> > the document. Is this a pin or a bit somewhere in the GRF - i.e. something
> > whichs state is readable?
> >
> >
> > Some more comments inline.
> >
> >> ---
> >>
> >> arch/arm/mach-rockchip/efuse.c | 165
> >>
> >> +++++++++++++++++++++++++++++++++++++++++ arch/arm/mach-rockchip/efuse.h
> >> |
> >> 15 ++++
> >>
> >> 2 files changed, 180 insertions(+)
> >> create mode 100644 arch/arm/mach-rockchip/efuse.c
> >> create mode 100644 arch/arm/mach-rockchip/efuse.h
> >>
> >> diff --git a/arch/arm/mach-rockchip/efuse.c
> >> b/arch/arm/mach-rockchip/efuse.c new file mode 100644
> >> index 0000000..326d81e
> >> --- /dev/null
> >> +++ b/arch/arm/mach-rockchip/efuse.c
> >
> > a driver like this should probably live in something like
> > drivers/soc/rockchip.
> >
> >> @@ -0,0 +1,165 @@
> >> +/* mach-rockchip/efuse.c
> >> + *
> >> + * Copyright (c) 2014 Rockchip Electronics Co. Ltd.
> >> + * Author: Jianqun Xu <jay.xu at rock-chips.com>
> >> + *
> >> + * Tmis program is free software; you can redistribute it and/or modify
> >> it
> >> + * under the terms of version 2 of the GNU General Public License as
> >> + * published by the Free Software Foundation.
> >> + *
> >> + * Tmis program is distributed in the hope that it will be useful, but
> >
> > type Tmis -> This
> >
> >> WITHOUT + * ANY WARRANTY; without even the implied warranty of
> >> MERCHANTABILITY or + * FITNESS FOR A PARTICULAR PURPOSE. See the GNU
> >> General Public License for + * more details.
> >> + *
> >> + * You should have received a copy of the GNU General Public License
> >> along
> >> with + * tmis program; if not, write to the Free Software Foundation,
> >> Inc.,
> >> + * 51 Franklin Street, Fifth Floor, Boston, MA 02110, USA
> >> + *
> >> + * Tme full GNU General Public License is included in this distribution
> >> in
> >> the + * file called LICENSE.
> >> + */
> >> +
> >> +#include <linux/kernel.h>
> >> +#include <linux/module.h>
> >> +#include <linux/device.h>
> >> +#include <linux/delay.h>
> >> +#include <linux/platform_device.h>
> >> +#include <linux/of_address.h>
> >> +#include <linux/io.h>
> >> +
> >> +#include "efuse.h"
> >> +
> >> +#define EFUSE_BUF_SIZE (32)
> >> +#define EFUSE_BUF_LKG_CPU (23)
> >> +#define EFUSE_BUF_LKG_GPU (24)
> >> +#define EFUSE_BUF_LKG_LOG (25)
> >
> > no braces needed for those numbers
> >
> >> +
> >> +struct rk_efuse_info {
> >> + /* Platform device */
> >> + struct device *dev;
> >> +
> >> + /* Hardware resources */
> >> + void __iomem *regs;
> >> +
> >> + /* buffer to store registers' values */
> >> + unsigned int buf[EFUSE_BUF_SIZE];
> >> +};
> >> +
> >> +static void efuse_writel(struct rk_efuse_info *efuse,
> >> + unsigned int value,
> >> + unsigned int offset)
> >> +{
> >> + writel_relaxed(value, efuse->regs + offset);
> >> +}
> >> +
> >> +static unsigned int efuse_readl(struct rk_efuse_info *efuse,
> >> + unsigned int offset)
> >> +{
> >> + return readl_relaxed(efuse->regs + offset);
> >> +}
> >
> > why these indirections for readl and writel? They don't seem to provide
> > any
> > additional benefit over calling writel_relaxed/readl_relaxed directly
> > below.>
> >> +
> >> +static unsigned int rockchip_efuse_leakage(struct rk_efuse_info *efuse,
> >> + int channel)
> >> +{
> >> + switch (channel) {
> >> + case EFUSE_BUF_LKG_CPU:
> >> + case EFUSE_BUF_LKG_GPU:
> >> + case EFUSE_BUF_LKG_LOG:
> >> + return efuse->buf[channel];
> >> + default:
> >> + dev_err(efuse->dev, "unknown channel\n");
> >> + return -EINVAL;
> >> + }
> >> +
> >> + return 0;
> >> +}
> >> +
> >> +static void rockchip_efuse_info(struct rk_efuse_info *efuse)
> >> +{
> >> + dev_info(efuse->dev, "leakage (%d %d %d)\n",
> >> + rockchip_efuse_leakage(efuse, EFUSE_BUF_LKG_CPU),
> >> + rockchip_efuse_leakage(efuse, EFUSE_BUF_LKG_GPU),
> >> + rockchip_efuse_leakage(efuse, EFUSE_BUF_LKG_LOG));
> >> +}
> >> +
> >> +static int rockchip_efuse_init(struct rk_efuse_info *efuse)
> >> +{
> >> + int start = 0;
> >> + int ret = 0;
> >> +
> >> + efuse_writel(efuse, EFUSE_CSB, REG_EFUSE_CTRL);
> >> + efuse_writel(efuse, EFUSE_LOAD | EFUSE_PGENB, REG_EFUSE_CTRL);
> >> + udelay(2);
> >> +
> >> + for (start = 0; start <= EFUSE_BUF_SIZE; start++) {
> >> + efuse_writel(efuse, efuse_readl(efuse, REG_EFUSE_CTRL) &
> >> + (~(EFUSE_A_MASK << EFUSE_A_SHIFT)),
> >> + REG_EFUSE_CTRL);
> >> + efuse_writel(efuse, efuse_readl(efuse, REG_EFUSE_CTRL) |
> >> + ((start & EFUSE_A_MASK) << EFUSE_A_SHIFT),
> >> + REG_EFUSE_CTRL);
> >> + udelay(2);
> >> + efuse_writel(efuse, efuse_readl(efuse, REG_EFUSE_CTRL) |
> >> + EFUSE_STROBE, REG_EFUSE_CTRL);
> >> + udelay(2);
> >> +
> >> + efuse->buf[start] = efuse_readl(efuse, REG_EFUSE_DOUT);
> >> +
> >> + efuse_writel(efuse, efuse_readl(efuse, REG_EFUSE_CTRL) &
> >> + (~EFUSE_STROBE), REG_EFUSE_CTRL);
> >> + udelay(2);
> >> + }
> >> +
> >> + udelay(2);
> >> + efuse_writel(efuse, efuse_readl(efuse, REG_EFUSE_CTRL) |
> >> + EFUSE_CSB, REG_EFUSE_CTRL);
> >> + udelay(2);
> >> +
> >> + return ret;
> >> +}
> >> +
> >> +static int rockchip_efuse_probe(struct platform_device *pdev)
> >> +{
> >> + struct rk_efuse_info *efuse;
> >> + struct resource *mem;
> >> + int ret = 0;
> >> +
> >> + efuse = devm_kzalloc(&pdev->dev, sizeof(*efuse), GFP_KERNEL);
> >> + if (!efuse)
> >> + return -ENOMEM;
> >> +
> >> + mem = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> >> + efuse->regs = devm_ioremap_resource(&pdev->dev, mem);
> >> + if (IS_ERR(efuse->regs))
> >> + return PTR_ERR(efuse->regs);
> >> +
> >> + platform_set_drvdata(pdev, efuse);
> >> + efuse->dev = &pdev->dev;
> >> +
> >> + ret = rockchip_efuse_init(efuse);
> >> + if (!ret)
> >> + rockchip_efuse_info(efuse);
> >> +
> >> + return ret;
> >> +}
> >> +
> >> +static const struct of_device_id rockchip_efuse_match[] = {
> >> + { .compatible = "rockchip,rk3288-efuse", },
> >
> > what about other Rockchip SoCs? At least the rk3188 seems to contain an
> > efuse [though the TRM I have only directs to a RK3188 eFuse.pdf without
> > describing the component. So I don't know if it's the same type.
> >
> >> + {},
> >> +};
> >> +
> >> +static struct platform_driver rockchip_efuse_driver = {
> >> + .probe = rockchip_efuse_probe,
> >> + .driver = {
> >> + .name = "rk3288-efuse",
> >> + .owner = THIS_MODULE,
> >
> > .owner gets already set through module_platform_driver
> >
> >> + .of_match_table = of_match_ptr(rockchip_efuse_match),
> >> + },
> >> +};
> >> +
> >> +module_platform_driver(rockchip_efuse_driver);
> >> +
> >> +MODULE_DESCRIPTION("Rockchip eFuse Driver");
> >> +MODULE_AUTHOR("Jianqun Xu <jay.xu at rock-chips.com>");
> >> +MODULE_LICENSE("GPL v2");
> >> diff --git a/arch/arm/mach-rockchip/efuse.h
> >> b/arch/arm/mach-rockchip/efuse.h new file mode 100644
> >> index 0000000..3fdcf6d
> >> --- /dev/null
> >> +++ b/arch/arm/mach-rockchip/efuse.h
> >
> > why does this need to be a separate header? The stuff below could very
> > well
> > simply live inside the fuse.c
> >
> >> @@ -0,0 +1,15 @@
> >> +#ifndef _ARCH_ROCKCHIP_EFUSE_H_
> >> +#define _ARCH_ROCKCHIP_EFUSE_H_
> >> +
> >> +/* Rockchip eFuse controller register */
> >> +#define EFUSE_A_SHIFT (6)
> >> +#define EFUSE_A_MASK (0x3FF)
> >> +#define EFUSE_PGENB (1 << 3)
> >
> > please use BIT(3) instead of (1 << 3)
> > Same for the bits below.
> >
> >> +#define EFUSE_LOAD (1 << 2)
> >> +#define EFUSE_STROBE (1 << 1)
> >> +#define EFUSE_CSB (1 << 0)
> >> +
> >> +#define REG_EFUSE_CTRL (0x0000)
> >> +#define REG_EFUSE_DOUT (0x0004)
> >
> > no braces necessary for basic numerals
> >
> >> +
> >> +#endif /* _ARCH_ROCKCHIP_EFUSE_H_ */
More information about the linux-arm-kernel
mailing list