[PATCH 2/6] ahci: st: Update the DT example for how to obtain the PHY.
Rob Herring
robherring2 at gmail.com
Wed Feb 25 06:33:20 PST 2015
On Wed, Feb 25, 2015 at 7:36 AM, Peter Griffin <peter.griffin at linaro.org> wrote:
> The example is wrong in that the phys property should take a
> phandle to the phy port.
>
> Also with the changing over to generic PHY type constants we also
> update this as well.
>
> Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
We seem to have a variety of ways to describe phy's with SATA
controllers. Some consistency would have been nice.
However, as this is a doc correction:
Acked-by: Rob Herring <robh at kernel.org>
> ---
> Documentation/devicetree/bindings/ata/ahci-st.txt | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/ata/ahci-st.txt b/Documentation/devicetree/bindings/ata/ahci-st.txt
> index 0574a77..1331202 100644
> --- a/Documentation/devicetree/bindings/ata/ahci-st.txt
> +++ b/Documentation/devicetree/bindings/ata/ahci-st.txt
> @@ -11,7 +11,7 @@ Required properties:
> - reset-names : Associated names must be; "pwr-dwn" and "sw-rst"
> - clocks : The phandle for the clock
> - clock-names : Associated name must be; "ahci_clk"
> - - phys : The phandle for the PHY device
> + - phys : The phandle for the PHY port
> - phy-names : Associated name must be; "ahci_phy"
>
> Example:
> @@ -21,7 +21,7 @@ Example:
> reg = <0xfe380000 0x1000>;
> interrupts = <GIC_SPI 157 IRQ_TYPE_NONE>;
> interrupt-names = "hostc";
> - phys = <&miphy365x_phy MIPHY_PORT_0 MIPHY_TYPE_SATA>;
> + phys = <&phy_port0 PHY_TYPE_SATA>;
> phy-names = "ahci_phy";
> resets = <&powerdown STIH416_SATA0_POWERDOWN>,
> <&softreset STIH416_SATA0_SOFTRESET>;
> --
> 1.9.1
>
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
More information about the linux-arm-kernel
mailing list