[PATCH 4/6] dmaengine: omap-dma: Take DMA request number from DT if it is available

[Russell King - ARM Linux]

On Tue, Feb 24, 2015 at 04:21:21PM +0200, Peter Ujfalusi wrote:
> Use the dma-requests property from DT to get the number of DMA requests.
> In case of legacy boot or failure to find the property, use the default
> 127 as number of requests.
> 
> Signed-off-by: Peter Ujfalusi <peter.ujfalusi at ti.com>
> ---
>  drivers/dma/omap-dma.c | 11 ++++++++++-
>  1 file changed, 10 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/dma/omap-dma.c b/drivers/dma/omap-dma.c
> index 56c33e93dd24..7def31c919f4 100644
> --- a/drivers/dma/omap-dma.c
> +++ b/drivers/dma/omap-dma.c
> @@ -34,6 +34,7 @@ struct omap_dmadev {
>  	const struct omap_dma_reg *reg_map;
>  	struct omap_system_dma_plat_info *plat;
>  	bool legacy;
> +	unsigned dma_requests;
>  	spinlock_t irq_lock;
>  	uint32_t irq_enable_mask;
>  	struct omap_chan *lch_map[OMAP_SDMA_CHANNELS];
> @@ -1118,7 +1119,15 @@ static int omap_dma_probe(struct platform_device *pdev)
>  
>  	tasklet_init(&od->task, omap_dma_sched, (unsigned long)od);
>  
> -	for (i = 0; i < OMAP_SDMA_REQUESTS; i++) {
> +	if (!pdev->dev.of_node || of_property_read_u32(pdev->dev.of_node,
> +						       "dma-requests",
> +						       &od->dma_requests)) {
> +		dev_info(&pdev->dev,
> +			 "DMA request lines not specified, using 127\n");
> +		od->dma_requests = 127;

What happened to OMAP_SDMA_REQUESTS?

If you're not going to use OMAP_SDMA_REQUESTS, then don't add it.  If
you are going to use it, please also change the dev_info() line to use
that macro too.

Thanks.

-- 
FTTC broadband for 0.8mile line: currently at 10.5Mbps down 400kbps up
according to speedtest.net.