[PATCH v9 5/5] ARM: dts: imx6qdl: Allow disabling the PU regulator, add a enable ramp delay

[Philipp Zabel]

The PU regulator is enabled during boot, but not necessarily always-on.
It can be disabled by the generic pm domain framework when the PU power
domain is shut down. The ramp delay of 150 us might be a bit conservative,
the value is taken from the Freescale kernel.

Signed-off-by: Philipp Zabel <p.zabel at pengutronix.de>
---
Changes since v8:
 - Removed regulator-boot-on, this depends on the bootloader
---
 arch/arm/boot/dts/imx6qdl.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/imx6qdl.dtsi b/arch/arm/boot/dts/imx6qdl.dtsi
index 7ab00a4..4b12ac0 100644
--- a/arch/arm/boot/dts/imx6qdl.dtsi
+++ b/arch/arm/boot/dts/imx6qdl.dtsi
@@ -598,7 +598,7 @@
 					regulator-name = "vddpu";
 					regulator-min-microvolt = <725000>;
 					regulator-max-microvolt = <1450000>;
-					regulator-always-on;
+					regulator-enable-ramp-delay = <150>;
 					anatop-reg-offset = <0x140>;
 					anatop-vol-bit-shift = <9>;
 					anatop-vol-bit-width = <5>;
-- 
2.1.4