[PATCH 3/4] arm: am33xx: DT quirks for am33xx based beaglebone variants

[Tony Lindgren]

* Pantelis Antoniou <pantelis.antoniou at konsulko.com> [150218 07:03]:
> Implement DT quirks for the am33xx beaglebone boards.
> --- /dev/null
> +++ b/arch/arm/mach-omap2/am33xx-dt-quirks.c
...
> +
> +/*
> + * The board IDs for am33xx board are in an I2C EEPROM
> + * We are very early in the boot process so we have to
> + * read the EEPROM directly without using the I2C layer.
> + *
> + * Note that we rely on the bootloader setting up the muxes
> + * (which is the case for u-boot).
> + */
> +
> +/* I2C Status Register (OMAP_I2C_STAT): */
> +#define OMAP_I2C_STAT_XDR	(1 << 14)	/* TX Buffer draining */
> +#define OMAP_I2C_STAT_RDR	(1 << 13)	/* RX Buffer draining */
> +#define OMAP_I2C_STAT_BB	(1 << 12)	/* Bus busy */
> +#define OMAP_I2C_STAT_ROVR	(1 << 11)	/* Receive overrun */
> +#define OMAP_I2C_STAT_XUDF	(1 << 10)	/* Transmit underflow */
> +#define OMAP_I2C_STAT_AAS	(1 << 9)	/* Address as slave */
> +#define OMAP_I2C_STAT_BF	(1 << 8)	/* Bus Free */
> +#define OMAP_I2C_STAT_XRDY	(1 << 4)	/* Transmit data ready */
> +#define OMAP_I2C_STAT_RRDY	(1 << 3)	/* Receive data ready */
> +#define OMAP_I2C_STAT_ARDY	(1 << 2)	/* Register access ready */
> +#define OMAP_I2C_STAT_NACK	(1 << 1)	/* No ack interrupt enable */
> +#define OMAP_I2C_STAT_AL	(1 << 0)	/* Arbitration lost int ena */
...

Uhh I don't like the idea of duplicating the i2c-omap.c driver under
arch/arm.. And in general we should initialize things later rather
than earlier.

What's stopping doing these quirk checks later on time with just
a regular device driver, something like drivers/misc/bbone-quirks.c?

Regards,

Tony