[PATCH v2] ARM: dts: zynq: Add OCM node

[Sören Brinkmann]

On Thu, 2015-02-12 at 12:01PM +0100, Michal Simek wrote:
> On 02/12/2015 11:54 AM, Mark Rutland wrote:
> > On Thu, Feb 12, 2015 at 10:42:47AM +0000, Michal Simek wrote:
> >> Add OCM node for all zynq boards. OCM location
> >> can changed but for all current boards this
> >> is the location where OCM is.`
> >>
> >> Signed-off-by: Michal Simek <michal.simek at xilinx.com>
> >> ---
> >>
> >> Changes in v2:
> >> - Move node to board file suggested by Mark
> >>
> >> This patch is done based on discussion here.
> >> https://lkml.org/lkml/2014/12/1/396
> >>
> >> Mark: I expect you won't like amba bus reference or
> >> am I wrong?
> > 
> > I'm fine with dropping things onto a bus in this way. If we're happy to
> > do it for other nodes I don't see why busses should be special.
> 
> Wonderful. I will give people some time to comment this style.

Given that the location is discoverable, wouldn't it make sense to let
'reg' point to the ctrl/cfg registers in the SLCR and let the driver
handle the whereabouts of the OCM location? (but I guess this is going
in circles now, such a proposal was on the table at some point, IIRC).
But I'd prefer:
	memory-controller at 0xfffc0000 { /* the address here would of course not match all configurations */
		interrupts = ...;
		syscon = &slcr;
	};

	Soren