[PATCH V2 RESEND] clk: mxs: Fix invalid 32-bit access to frac registers

[Marek Vasut]

On Tuesday, February 10, 2015 at 10:54:52 PM, Fabio Estevam wrote:
> Hi Stefan,
> 
> On Tue, Feb 10, 2015 at 7:24 PM, Stefan Wahren <stefan.wahren at i2se.com> wrote:
> > thanks this is very helpful. I built the linux-next for my Duckbill and
> > add the SSP2 section from imx28-evk.dts into imx28-duckbill.dts.
> > 
> > Without my patch i get the following for HW_CLKCTRL_FRAC0:
> > 
> > ./memwatch -a 0x800401B0
> > 
> > 0x800401b0: 0x5e5b5513
> > 
> > With my patch i get:
> > 
> > ./memwatch -a 0x800401B0
> > 
> > 0x800401b0: 0x5e1b5513
> > 
> > So it looks like a problem in my patch.
> 
> Yes, let's try to get the same value HW_CLKCTRL_FRAC0.
> 
> > I orded such a flash chip, but it will take some time until i can use it
> > with my hardware.
> 
> Thanks for doing this.
> 
> Maybe if you find out a way to fix the calculation of
> HW_CLKCTRL_FRAC0, then I can test it on my board.

Hi,

the difference is this 0x40 bit, right ? That's _STABLE bit, so it means
the clock are not stable, right ? Why would that happen in the first place?

Best regards,
Marek Vasut