[PATCH v9 3/3] ARM: dts: add I2C device nodes for Broadcom Cygnus

[Ray Jui]

On 2/9/2015 4:11 AM, Wolfram Sang wrote:
> On Sat, Feb 07, 2015 at 09:25:26PM -0800, Ray Jui wrote:
>> Add I2C device nodes and its properties in bcm-cygnus.dtsi but keep
>> them disabled there. Individual I2C devices can be enabled in board
>> specific dts file when I2C slave devices are enabled in the future
>>
>> Signed-off-by: Ray Jui <rjui at broadcom.com>
>> Reviewed-by: Scott Branden <sbranden at broadcom.com>
>> Reviewed-by: Kevin Cernekee <cernekee at chromium.org>
> 
> I usually don't take DTS patches. They should go via arm-soc. Please say
> so if there are reasons I should take them.
> 
Okay. I'll send this as an individual patch to arm-soc.

Thanks,

Ray