[RESEND PATCHv6 5/5] arm: dts: Add Altera L2 Cache and OCRAM EDAC entries

[Thor Thayer]

Hi Device Tree Maintainers,

On 01/08/2015 08:53 PM, tthayer at opensource.altera.com wrote:
> From: Thor Thayer <tthayer at opensource.altera.com>
>
> Adding the device tree entries and bindings needed to support
> the Altera L2 cache and On-Chip RAM EDAC. This patch relies upon
> an earlier patch to declare and setup On-chip RAM properly.
> http://www.spinics.net/lists/devicetree/msg51117.html
>
> Signed-off-by: Thor Thayer <tthayer at opensource.altera.com>
> ---
> v2: Remove OCRAM declaration and reference prior patch.
>
> v3-5: No Change
>
> v6: Change to nested EDAC device nodes based on community
>      feedback. Remove L2 syscon. Use consolidated binding.

I'm requesting comments on this patch series. The changes in this patch 
series are based upon feedback from Mark Rutland for patch series 
version 5 on December 2, 2014.

I believe this patch set addresses the concerns that Mark had with my 
previous patch. Primarily, syscon was removed from the L2 cache and a 
top level device tree node with L2 and OCRAM children is used instead of 
individual top level nodes. Some concerns were addressed in an email 
reply on December 2, 2014.

This change also created a new edac parent probe function which is in 
[PATCHv6 4/5] which should be reviewed along with this device tree change.

Thanks,

Thor

> ---
>   .../bindings/arm/altera/socfpga-edac.txt           |   46 ++++++++++++++++++++
>   arch/arm/boot/dts/socfpga.dtsi                     |   20 +++++++++
>   2 files changed, 66 insertions(+)
>   create mode 100644 Documentation/devicetree/bindings/arm/altera/socfpga-edac.txt
>
> diff --git a/Documentation/devicetree/bindings/arm/altera/socfpga-edac.txt b/Documentation/devicetree/bindings/arm/altera/socfpga-edac.txt
> new file mode 100644
> index 0000000..4bf32e1
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/arm/altera/socfpga-edac.txt
> @@ -0,0 +1,46 @@
> +Altera SoCFPGA Error Detection and Correction [EDAC]
> +
> +Required Properties:
> +- compatible : Should be "altr,edac"
> +- #address-cells: must be 1
> +- #size-cells: must be 1
> +- ranges : standard definition, should translate from local addresses
> +
> +Subcomponents:
> +
> +L2 Cache ECC
> +Required Properties:
> +- compatible : Should be "altr,l2-edac"
> +- reg : Address and size for ECC error interrupt clear registers.
> +- interrupts : Should be single bit error interrupt, then double bit error
> +	interrupt. Note the rising edge type.
> +
> +On Chip RAM ECC
> +Required Properties:
> +- compatible : Should be "altr,ocram-edac"
> +- reg : Address and size for ECC error interrupt clear registers.
> +- iram : phandle to On-Chip RAM definition.
> +- interrupts : Should be single bit error interrupt, then double bit error
> +	interrupt. Note the rising edge type.
> +
> +Example:
> +
> +	soc_ecc {
> +		compatible = "altr,edac";
> +		#address-cells = <1>;
> +		#size-cells = <1>;
> +		ranges;
> +
> +		l2edac at ffd08140 {
> +			compatible = "altr,l2-edac";
> +			reg = <0xffd08140 0x4>;
> +			interrupts = <0 36 1>, <0 37 1>;
> +		};
> +
> +		ocramedac at ffd08144 {
> +			compatible = "altr,ocram-edac";
> +			reg = <0xffd08144 0x4>;
> +			iram = <&ocram>;
> +			interrupts = <0 178 1>, <0 179 1>;
> +		};
> +	};
> diff --git a/arch/arm/boot/dts/socfpga.dtsi b/arch/arm/boot/dts/socfpga.dtsi
> index 252c3d1..e546e47 100644
> --- a/arch/arm/boot/dts/socfpga.dtsi
> +++ b/arch/arm/boot/dts/socfpga.dtsi
> @@ -618,6 +618,26 @@
>   			interrupts = <0 39 4>;
>   		};
>
> +		soc_ecc {
> +			compatible = "altr,edac";
> +			#address-cells = <1>;
> +			#size-cells = <1>;
> +			ranges;
> +
> +			l2edac at ffd08140 {
> +				compatible = "altr,l2-edac";
> +				reg = <0xffd08140 0x4>;
> +				interrupts = <0 36 1>, <0 37 1>;
> +			};
> +
> +			ocramedac at ffd08144 {
> +				compatible = "altr,ocram-edac";
> +				reg = <0xffd08144 0x4>;
> +				iram = <&ocram>;
> +				interrupts = <0 178 1>, <0 179 1>;
> +			};
> +		};
> +
>   		L2: l2-cache at fffef000 {
>   			compatible = "arm,pl310-cache";
>   			reg = <0xfffef000 0x1000>;
>