[PATCH] mmc: core: add runtime-resume caps to support resume at runtime_resume

[Mark Rutland]

On Thu, Feb 05, 2015 at 11:06:59AM +0000, Addy Ke wrote:
> Signed-off-by: Addy Ke <addy.ke at rock-chips.com>
> ---
>  Documentation/devicetree/bindings/mmc/mmc.txt | 11 +++++++++++
>  drivers/mmc/core/host.c                       |  2 ++
>  2 files changed, 13 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/mmc/mmc.txt b/Documentation/devicetree/bindings/mmc/mmc.txt
> index 438899e..303b448 100644
> --- a/Documentation/devicetree/bindings/mmc/mmc.txt
> +++ b/Documentation/devicetree/bindings/mmc/mmc.txt
> @@ -40,9 +40,20 @@ Optional properties:
>  - mmc-hs200-1_2v: eMMC HS200 mode(1.2V I/O) is supported
>  - mmc-hs400-1_8v: eMMC HS400 mode(1.8V I/O) is supported
>  - mmc-hs400-1_2v: eMMC HS400 mode(1.2V I/O) is supported
> +- runtime-resume: resume at runtime_resume is supported

This reads like description of Linux internals (runtime_resume), which
shouldn't be in the DT.

What does this mean at the HW level? I'm sure we can find a better name
for this, or another way of describing this.

>  - dsr: Value the card's (optional) Driver Stage Register (DSR) should be
>    programmed with. Valid range: [0 .. 0xffff].
>  
> +Card power and reset control:
> +The following properties can be specified for cases where the MMC
> +peripheral needs additional reset, regulator and clock lines. It is for
> +example common for WiFi/BT adapters to have these separate from the main
> +MMC bus:
> +  - card-reset-gpios: Specify GPIOs for card reset (reset active low)
> +  - card-external-vcc-supply: Regulator to drive (independent) card VCC
> +  - clock with name "card_ext_clock": External clock provided to the card

Are these proeprties placed on the MMC controller node, or a sub-node
representing the card/slot?

Thanks,
Mark.