[PATCH RFC v8 00/21] Add support for i.MX MIPI DSI DRM driver

Sun Feb 1 21:34:40 PST 2015

Correct Philipp's email address in the Cc list.

Liu Ying

On Mon, Feb 02, 2015 at 10:17:45AM +0800, Liu Ying wrote:
> Hi,
> 
> This version has been submitted for a while.
> And, it looks there is no comments on this version.
> Can the maintainers consider to take this?
> 
> Mike, any comments on patch 01/21?  It's a clock driver change.
> 
> Regards,
> Liu Ying
> 
> On Wed, Dec 31, 2014 at 04:23:18PM +0800, Liu Ying wrote:
> > Hi,
> > 
> > This version mainly fixes the Kconfig for the Synopsys DesignWare MIPI DSI
> > host controller bridge driver so that we may pass the allmodconfig for ARM.
> > Also, this version contains a minor change for the Himax HX8369A panel
> > driver to remove several unnecessary headers included.
> > 
> > The i.MX MIPI DSI is a Synopsys DesignWare MIPI DSI host controller IP.
> > This series adds support for a Synopsys DesignWare MIPI DSI host controller
> > DRM bridge driver and a i.MX MIPI DSI specific DRM driver.
> > Currently, the MIPI DSI drivers only support the burst with sync pulse mode.
> > 
> > This series also includes a DRM panel driver for the Truly TFT480800-16-E panel
> > which is driven by the Himax HX8369A driver IC.  The driver IC data sheet could
> > be found at [1].  As mentioned by the data sheet, the driver IC supports several
> > interface modes.  Currently, the DRM panel driver only supports the MIPI DSI video
> > mode.  New interface modes could be added later(perhaps, just like the way the DRM
> > simple panel driver supports both MIPI DSI interface panels and simple(parallel)
> > interface panels).
> > 
> > The MIPI DSI feature is tested on i.MX6Q SabreSD board and i.MX6DL SabreSD board.
> > The MIPI DSI display could be enabled directly on i.MX6Q SabreSD board after
> > applying this series, because the 26.4MHz pixel clock the panel requires could be
> > derived from the IPU HSP clock(264MHz) with an integer divider.
> > On i.MX6DL SabreSD board, we need to manually disable the LVDS and HDMI displays in
> > the device tree blob, since the i.MX6DL IPU HSP clock is 198MHz at present, which
> > makes the pixel clock share the PLL5 video clock source with the LVDS and HDMI,
> > thus, the panel cannot get the pixel clock rate it wants.
> > 
> > Patch 01/21 is needed to get a precise pixel clock rate(26.4MHz) from the PLL5 video
> > clock.  If we don't have this patch, the pixel clock rate is about 20MHz, which
> > causes a horitonal shift on the display image.
> > 
> > This series can be applied on the drm-next branch.
> > 
> > [1] http://www.allshore.com/pdf/Himax_HX8369-A.pdf
> > 
> > Liu Ying (21):
> >   clk: divider: Correct parent clk round rate if no bestdiv is normally
> >     found
> >   of: Add vendor prefix for Himax Technologies Inc.
> >   of: Add vendor prefix for Truly Semiconductors Limited
> >   ARM: imx6q: Add GPR3 MIPI muxing control register field shift bits
> >     definition
> >   ARM: imx6q: clk: Add the video_27m clock
> >   ARM: imx6q: clk: Change hdmi_isfr clock's parent to be video_27m clock
> >   ARM: imx6q: clk: Change hsi_tx clock to be a shared clock gate
> >   ARM: imx6q: clk: Add support for mipi_core_cfg clock as a shared clock
> >     gate
> >   ARM: dts: imx6qdl: Move existing MIPI DSI ports into a new 'ports'
> >     node
> >   drm/dsi: Add a helper to get bits per pixel of MIPI DSI pixel format
> >   Documentation: dt-bindings: Add bindings for Synopsys DW MIPI DSI DRM
> >     bridge driver
> >   drm/bridge: Add Synopsys DesignWare MIPI DSI host controller driver
> >   Documentation: dt-bindings: Add bindings for i.MX specific Synopsys DW
> >     MIPI DSI driver
> >   drm: imx: Support Synopsys DesignWare MIPI DSI host controller
> >   Documentation: dt-bindings: Add bindings for Himax HX8369A DRM panel
> >     driver
> >   drm: panel: Add support for Himax HX8369A MIPI DSI panel
> >   ARM: dtsi: imx6qdl: Add support for MIPI DSI host controller
> >   ARM: dts: imx6qdl-sabresd: Add support for TRULY TFT480800-16-E MIPI
> >     DSI panel
> >   ARM: imx_v6_v7_defconfig: Cleanup for imx drm being moved out of
> >     staging
> >   ARM: imx_v6_v7_defconfig: Add support for MIPI DSI host controller
> >   ARM: imx_v6_v7_defconfig: Add support for Himax HX8369A panel
> > 
> >  .../devicetree/bindings/drm/bridge/dw_mipi_dsi.txt |  73 ++
> >  .../devicetree/bindings/drm/imx/mipi_dsi.txt       |  78 ++
> >  .../devicetree/bindings/panel/himax,hx8369a.txt    |  39 +
> >  .../devicetree/bindings/vendor-prefixes.txt        |   2 +
> >  arch/arm/boot/dts/imx6q.dtsi                       |  20 +-
> >  arch/arm/boot/dts/imx6qdl-sabresd.dtsi             |  20 +
> >  arch/arm/boot/dts/imx6qdl.dtsi                     |  29 +-
> >  arch/arm/configs/imx_v6_v7_defconfig               |  17 +-
> >  arch/arm/mach-imx/clk-imx6q.c                      |   7 +-
> >  drivers/clk/clk-divider.c                          |   3 +-
> >  drivers/gpu/drm/bridge/Kconfig                     |  10 +
> >  drivers/gpu/drm/bridge/Makefile                    |   1 +
> >  drivers/gpu/drm/bridge/dw_mipi_dsi.c               | 996 +++++++++++++++++++++
> >  drivers/gpu/drm/imx/Kconfig                        |   7 +
> >  drivers/gpu/drm/imx/Makefile                       |   1 +
> >  drivers/gpu/drm/imx/dw_mipi_dsi-imx.c              | 230 +++++
> >  drivers/gpu/drm/panel/Kconfig                      |   5 +
> >  drivers/gpu/drm/panel/Makefile                     |   1 +
> >  drivers/gpu/drm/panel/panel-himax-hx8369a.c        | 610 +++++++++++++
> >  include/drm/bridge/dw_mipi_dsi.h                   |  27 +
> >  include/drm/drm_mipi_dsi.h                         |  14 +
> >  include/dt-bindings/clock/imx6qdl-clock.h          |   4 +-
> >  include/linux/mfd/syscon/imx6q-iomuxc-gpr.h        |   1 +
> >  23 files changed, 2165 insertions(+), 30 deletions(-)
> >  create mode 100644 Documentation/devicetree/bindings/drm/bridge/dw_mipi_dsi.txt
> >  create mode 100644 Documentation/devicetree/bindings/drm/imx/mipi_dsi.txt
> >  create mode 100644 Documentation/devicetree/bindings/panel/himax,hx8369a.txt
> >  create mode 100644 drivers/gpu/drm/bridge/dw_mipi_dsi.c
> >  create mode 100644 drivers/gpu/drm/imx/dw_mipi_dsi-imx.c
> >  create mode 100644 drivers/gpu/drm/panel/panel-himax-hx8369a.c
> >  create mode 100644 include/drm/bridge/dw_mipi_dsi.h
> > 
> > -- 
> > 2.1.0
> > 
> > _______________________________________________
> > dri-devel mailing list
> > dri-devel at lists.freedesktop.org
> > http://lists.freedesktop.org/mailman/listinfo/dri-devel
> _______________________________________________
> dri-devel mailing list
> dri-devel at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/dri-devel