[RFC PATCH 2/5] doc: dt-binding: generic onboard USB device

[Rob Herring]

On Fri, Dec 18, 2015 at 05:33:56PM +0800, Peter Chen wrote:
> Add dt-binding documentation for generic onboard USB device.

As has already been mentioned, please following the existing USB device 
binding convention. We can debate whether the kernel driver is tied into 
existing USB drivers or separate platform drivers, but the binding needs 
to reflect the h/w.

Rob

> 
> Signed-off-by: Peter Chen <peter.chen at freescale.com>
> ---
>  .../bindings/usb/generic-onboard-device.txt        | 31 ++++++++++++++++++++++
>  1 file changed, 31 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/usb/generic-onboard-device.txt
> 
> diff --git a/Documentation/devicetree/bindings/usb/generic-onboard-device.txt b/Documentation/devicetree/bindings/usb/generic-onboard-device.txt
> new file mode 100644
> index 0000000..cdb3014
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/usb/generic-onboard-device.txt
> @@ -0,0 +1,31 @@
> +Generic Onboard USB Device 
> +
> +The node should be located at USB host controller's node or
> +any USB HUB's node.
> +
> +Required properties:
> +- compatible: should be "generic-onboard-device"
> +
> +Optional properties:
> +- clocks: the input clock for USB device.
> +- clock-frequency: the frequency for device's clock.
> +- reset-gpios: Should specify the GPIO for reset.
> +- reset-duration-us: the duration for assert reset signal, the time unit
> +  is microsecond.
> +
> +Example:
> +
> +&usbh1 {
> +	vbus-supply = <&reg_usb_h1_vbus>;
> +        status = "okay";
> +
> +	#address-cells = <1>;
> +	#size-cells = <0>;
> +	hub: usb2415 at 01 {
> +	       compatible = "generic-onboard-device";
> +	       reg = <0x01>;
> +	       clocks = <&clks IMX6QDL_CLK_CKO>;
> +	       reset-gpios = <&gpio7 12 GPIO_ACTIVE_LOW>;
> +	       reset-duration-us = <10>;
> +	};
> +};
> -- 
> 1.9.1
>