[PATCH] net/macb: add support for resetting PHY using GPIO

[Sascha Hauer]

Hi Gregory,

On Wed, Dec 09, 2015 at 06:49:43PM +0100, Gregory CLEMENT wrote:
> With device tree it is no more possible to reset the PHY at board
> level. Furthermore, doing in the driver allow to power down the PHY when
> the network interface is no more used.
> 
> The patch introduces a new optional property "phy-reset-gpio" inspired
> from the one use for the FEC.

I don't think it's a good idea to further extend the usage of this
binding. The driver should use the phy-handle property and
of_phy_connect() which gives you a proper device node for the phy. Then
the phy device node should get the reset gpio. I know it's more work,
but doing it like this gives you additional goodies like proper handling
of the max-speed property, a fixed-link if necessary and picking the
correct phy if there are muliple phys on the bus.

Sascha

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |