[PATCH 3/3] ARM: dts: Addition of binding for gpio switches on peach-pi

Martyn Welch martyn.welch at collabora.co.uk
Fri Dec 4 09:31:15 PST 2015


The peach pi has a GPIO connected to the firmware write protect, developer
mode and recovery mode lines (which are primarily controlled via external
switches on developer test board). This patch adds the required nodes to
the device tree to configure the pinmuxing and allow these to be read from
user space.

Signed-off-by: Martyn Welch <martyn.welch at collabora.co.uk>
---
 arch/arm/boot/dts/exynos5800-peach-pi.dts | 46 +++++++++++++++++++++++++++++++
 1 file changed, 46 insertions(+)

diff --git a/arch/arm/boot/dts/exynos5800-peach-pi.dts b/arch/arm/boot/dts/exynos5800-peach-pi.dts
index 49a4f43..2937372 100644
--- a/arch/arm/boot/dts/exynos5800-peach-pi.dts
+++ b/arch/arm/boot/dts/exynos5800-peach-pi.dts
@@ -53,6 +53,31 @@
 		};
 	};
 
+	gpio-switch {
+		compatible = "gpio-switch";
+
+		pinctrl-names = "default";
+		pinctrl-0 = <&wp_gpio &dev_mode &rec_mode>;
+
+		write-protect {
+			label = "write-protect";
+			gpios = <&gpx3 0 GPIO_ACTIVE_LOW>;
+			read-only;
+		};
+
+		developer-switch {
+			label = "developer-switch";
+			gpios = <&gpx1 3 GPIO_ACTIVE_HIGH>;
+			read-only;
+		};
+
+		recovery-switch {
+			label = "recovery-switch";
+			gpios = <&gpx0 7 GPIO_ACTIVE_LOW>;
+			read-only;
+		};
+	};
+
 	gpio-keys {
 		compatible = "gpio-keys";
 
@@ -731,6 +756,13 @@
 		samsung,pin-val = <0>;
 	};
 
+	rec_mode: rec-mode {
+		samsung,pins = "gpx0-7";
+		samsung,pin-function = <0>;
+		samsung,pin-pud = <0>;
+		samsung,pin-drv = <0>;
+	};
+
 	tpm_irq: tpm-irq {
 		samsung,pins = "gpx1-0";
 		samsung,pin-function = <0>;
@@ -752,6 +784,13 @@
 		samsung,pin-drv = <0>;
 	};
 
+	dev_mode: dev-mode {
+		samsung,pins = "gpx1-3";
+		samsung,pin-function = <0>;
+		samsung,pin-pud = <3>;
+		samsung,pin-drv = <0>;
+	};
+
 	ec_irq: ec-irq {
 		samsung,pins = "gpx1-5";
 		samsung,pin-function = <0>;
@@ -773,6 +812,13 @@
 		samsung,pin-drv = <0>;
 	};
 
+	wp_gpio: wp_gpio {
+		samsung,pins = "gpx3-0";
+		samsung,pin-function = <0>;
+		samsung,pin-pud = <0>;
+		samsung,pin-drv = <0>;
+	};
+
 	max77802_irq: max77802-irq {
 		samsung,pins = "gpx3-1";
 		samsung,pin-function = <0>;
-- 
2.1.4




More information about the linux-arm-kernel mailing list