[RFC PATCH 7/9] drm/rockchip: force enable vop when do mode setting
daniel at ffwll.ch
Wed Dec 2 14:17:10 PST 2015
On Wed, Dec 02, 2015 at 05:55:36PM +0100, Thierry Reding wrote:
> On Tue, Dec 01, 2015 at 11:32:01AM +0800, Mark Yao wrote:
> > When do mode setting, mean that we want to enable display output,
> > but sometimes, vop_crtc_enable is after mode_set, we can't allow
> > that, so force enable vop in mode setting.
> > Signed-off-by: Mark Yao <mark.yao at rock-chips.com>
> > ---
> > drivers/gpu/drm/rockchip/rockchip_drm_vop.c | 1 +
> > 1 file changed, 1 insertion(+)
> > diff --git a/drivers/gpu/drm/rockchip/rockchip_drm_vop.c b/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
> > index c65b454..7c07537 100644
> > --- a/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
> > +++ b/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
> > @@ -1110,6 +1110,7 @@ static void vop_crtc_mode_set_nofb(struct drm_crtc *crtc)
> > u16 vact_end = vact_st + vdisplay;
> > uint32_t val;
> > + vop_crtc_enable(crtc);
> > /*
> > * If dclk rate is zero, mean that scanout is stop,
> > * we don't need wait any more.
> Have you considered simply moving everything into ->enable()? That's
> what I did for Tegra, for much the same reasons that you gave in the
> commit message. Doing so gives you a much simpler call graph. Really
> the only thing you need to do is move around the code, and perhaps a
> different way to get ahold of the display mode, but you can use the
> Tegra driver as a reference for how to do that.
Yeah if writing mode related registers requires the thing to be on on your
hw then you can't use the ->mode_set hooks. Those are explicitly called
when everything is off (not just sometimes, at least with atomic helpers).
Like Thierry said the recommendation is to just shovel that code into
->enable hooks. ->mode_set_nofb is mostly there to support easier
transition for drivers which started with the legacy crtc helpers.
Software Engineer, Intel Corporation
More information about the linux-arm-kernel