[PATCH RFC 0/3] input: rotary_encoder: use more than two gpios as input

[Rojhalat Ibrahim]

On Wednesday 02 December 2015 11:07:11 Uwe Kleine-König wrote:
> Hello,
> 
> some time ago I worked on the rotary encoder driver to make it support
> more than two input lines. This is the (only slightly tested[1]) rebase of
> this series on top of 4.4-rc2 (from 4.1).
> 
> It would be great to get some feedback, especially (but not only) for my
> change to raumfeld.c.
> 
> Before Ezequiel's patch 3a341a4c30d4 ("Input: rotary-encoder - add
> support for quarter-period mode") we had a dt property
> "rotary-encoder,half-period" defined. It's presence meant that we had 2
> indents per period; it's absence that there is only 1. Ezequiel
> introduced rotary-encoder,steps-per-period instead when adding support
> for quarter-period mode (which has 4 indents per period).
> 
> Up to now (i.e. with two inputs) a period has length 4. Now with (say)
> four inputs a period has length 16 instead. Now how should this be
> modeled in dt? This series implements that I have to pass
> 
> 	rotary-encoder,steps-per-period = <16>;
> 
> now for "quarter-period mode" (i.e. 4 indents per 4 state changes[2]),
> but that feels unnatural. I'd prefer to set a property to <1> instead,
> meaning the device has an indent for each state change[2]. half-period
> mode would be <2> and full-period mode would be <4>. But I don't have a
> nice name for such a property and maybe it's easier to live with
> steps-per-period = <16>? What do you think?
> 
> Also note that these patches are not as technically versatile as
> possible. With 4 (n) input lines we could detect a quick rotation where the
> machine's latency only allows to sample after 7 (2^(n-1)-1) state
> changes. Currently this is not implemented, but can be done later.
> 
> Best regards
> Uwe
> 

AFAIUI the rotary encoder driver only handles incremental encoders not
absolute encoders. (So in fact the assumed rotary encoder could also be a
linear encoder with an incremental interface.) Those encoders almost always
have an interface with two outputs (A, B) with a phase shift of 90 degrees
between them. So in this case we have 4 steps per period. Sometimes there
is only one line for 1 or 2 steps per period. But I have never seen or
heard of a device with more than 2 lines (except for the third output which
serves as a reference position index marker).

Do devices wirh more than two outputs actually exist?
Or is the purpose of supporting more than 2 lines something other than
connecting an actual encoder to them?

   Rojhalat