[PATCH v3 2/5] ARM: NSP: add minimal Northstar Plus device tree

Jon Mason jonmason at broadcom.com
Sun Aug 30 19:24:17 PDT 2015


On Fri, Aug 28, 2015 at 05:20:20PM -0700, Ray Jui wrote:
> 
> 
> On 8/28/2015 4:47 PM, Jon Mason wrote:
> > Add a very minimalistic set of Northstar Plus Device Tree files which
> > describes the SoC and the BCM958625 implementation.  The perpherials
> > described are:
> > 
> > ARM Cortex A9 CPU
> > 2 8250 UARTs
> > ARM GIC
> > PL310 L2 Cache
> > ARM A9 Global timer
> > 
> > Signed-off-by: Kapil Hali <kapilh at broadcom.com>
> > Signed-off-by: Jon Mason <jonmason at broadcom.com>
> > ---
> >  arch/arm/boot/dts/Makefile       |   2 +
> >  arch/arm/boot/dts/bcm-nsp.dtsi   | 120 +++++++++++++++++++++++++++++++++++++++
> >  arch/arm/boot/dts/bcm958625k.dts |  57 +++++++++++++++++++
> >  3 files changed, 179 insertions(+)
> >  create mode 100644 arch/arm/boot/dts/bcm-nsp.dtsi
> >  create mode 100644 arch/arm/boot/dts/bcm958625k.dts
> > 
> > diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile
> > index 246473a..adb5732 100644
> > --- a/arch/arm/boot/dts/Makefile
> > +++ b/arch/arm/boot/dts/Makefile
> > @@ -82,6 +82,8 @@ dtb-$(CONFIG_ARCH_BCM_CYGNUS) += \
> >  dtb-$(CONFIG_ARCH_BCM_MOBILE) += \
> >  	bcm28155-ap.dtb \
> >  	bcm21664-garnet.dtb
> > +dtb-$(CONFIG_ARCH_BCM_NSP) += \
> > +	bcm958625k.dtb
> >  dtb-$(CONFIG_ARCH_BERLIN) += \
> >  	berlin2-sony-nsz-gs7.dtb \
> >  	berlin2cd-google-chromecast.dtb \
> > diff --git a/arch/arm/boot/dts/bcm-nsp.dtsi b/arch/arm/boot/dts/bcm-nsp.dtsi
> > new file mode 100644
> > index 0000000..f5f494f
> > --- /dev/null
> > +++ b/arch/arm/boot/dts/bcm-nsp.dtsi
> > @@ -0,0 +1,120 @@
> > +/*
> > + *  BSD LICENSE
> > + *
> > + *  Copyright(c) 2015 Broadcom Corporation.  All rights reserved.
> > + *
> > + *  Redistribution and use in source and binary forms, with or without
> > + *  modification, are permitted provided that the following conditions
> > + *  are met:
> > + *
> > + *    * Redistributions of source code must retain the above copyright
> > + *      notice, this list of conditions and the following disclaimer.
> > + *    * Redistributions in binary form must reproduce the above copyright
> > + *      notice, this list of conditions and the following disclaimer in
> > + *      the documentation and/or other materials provided with the
> > + *      distribution.
> > + *    * Neither the name of Broadcom Corporation nor the names of its
> > + *      contributors may be used to endorse or promote products derived
> > + *      from this software without specific prior written permission.
> > + *
> > + *  THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
> > + *  "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
> > + *  LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
> > + *  A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
> > + *  OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
> > + *  SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
> > + *  LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
> > + *  DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
> > + *  THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
> > + *  (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
> > + *  OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
> > + */
> > +
> > +#include <dt-bindings/interrupt-controller/arm-gic.h>
> > +#include <dt-bindings/interrupt-controller/irq.h>
> > +
> > +#include "skeleton.dtsi"
> > +
> > +/ {
> > +	compatible = "brcm,nsp";
> > +	model = "Broadcom Northstar Plus SoC";
> > +	interrupt-parent = <&gic>;
> > +
> > +	mpcore {
> > +		compatible = "simple-bus";
> > +		ranges = <0x00000000 0x19020000 0x00003000>;
> > +		#address-cells = <1>;
> > +		#size-cells = <1>;
> > +
> > +		cpus {
> > +			#address-cells = <1>;
> > +			#size-cells = <0>;
> > +
> > +			cpu at 0 {
> > +				device_type = "cpu";
> > +				compatible = "arm,cortex-a9";
> > +				next-level-cache = <&L2>;
> > +				reg = <0x0>;
> > +			};
> > +		};
> > +
> > +		L2: l2-cache {
> > +			compatible = "arm,pl310-cache";
> > +			reg = <0x2000 0x1000>;
> > +			cache-unified;
> > +			cache-level = <2>;
> > +		};
> > +
> > +		gic: interrupt-controller at 19021000 {
> > +			compatible = "arm,cortex-a9-gic";
> > +			#interrupt-cells = <3>;
> > +			#address-cells = <0>;
> > +			interrupt-controller;
> > +			reg = <0x1000 0x1000>,
> > +			      <0x0100 0x100>;
> > +		};
> > +
> > +		timer at 19020200 {
> > +			compatible = "arm,cortex-a9-global-timer";
> > +			reg = <0x0200 0x100>;
> > +			interrupts = <GIC_PPI 11 IRQ_TYPE_LEVEL_HIGH>;
> > +			clocks = <&periph_clk>;
> > +		};
> > +	};
> > +
> > +	clocks {
> > +		#address-cells = <1>;
> > +		#size-cells = <1>;
> > +		ranges;
> > +
> > +		periph_clk: periph_clk {
> > +			compatible = "fixed-clock";
> > +			#clock-cells = <0>;
> > +			clock-frequency = <500000000>;
> > +		};
> > +	};
> > +
> > +	apb {
> > +		compatible = "arm,amba-bus", "simple-bus";
> 
> Should "arm,amba-bus" has a separate bus node with AMBA compatible
> devices declared in there (e.g, pl330, spi-pl022, and etc.) in the
> future after they are brought up? To my best knowledge, "ns16550a" UART
> is NOT an AMBA compatible device.

APB is an AMBA bus, so this part is accurate.  The block diagram of
the SoC has the UARTs (and other perpherials) hanging off of the APB
bus.  So, this organization follows the block diagram.  While the
UART drivers are not AMBA aware, there appears to be no issues with
this layout (as the HW/drivers come up without issue).  Unless there
is an unforeseen issue with having non-AMBA aware devices on the DT
AMBA bus, I would think it best to organize it to match the block
disgram.

> > +		interrupt-parent = <&gic>;
> > +		ranges = <0x00000000 0x18000000 0x00001000>;
> 
> Does the 'apb' bus mean to cover all peripherals connected through APB?
> If so, the size is only 0x1000 and that seems to be too small...

This is all that is currently needed.  I was planning on expanding it
as I added more devices.

Thanks,
Jon

> > +		#address-cells = <1>;
> > +		#size-cells = <1>;
> > +
> > +		uart0: serial at 18000300 {
> > +			compatible = "ns16550a";
> > +			reg = <0x0300 0x100>;
> > +			interrupts = <GIC_SPI 85 IRQ_TYPE_LEVEL_HIGH>;
> > +			clock-frequency = <62499840>;
> > +			status = "disabled";
> > +		};
> > +
> > +		uart1: serial at 18000400 {
> > +			compatible = "ns16550a";
> > +			reg = <0x0400 0x100>;
> > +			interrupts = <GIC_SPI 85 IRQ_TYPE_LEVEL_HIGH>;
> > +			clock-frequency = <62499840>;
> > +			status = "disabled";
> > +		};
> > +	};
> > +};
> > diff --git a/arch/arm/boot/dts/bcm958625k.dts b/arch/arm/boot/dts/bcm958625k.dts
> > new file mode 100644
> > index 0000000..16303db
> > --- /dev/null
> > +++ b/arch/arm/boot/dts/bcm958625k.dts
> > @@ -0,0 +1,57 @@
> > +/*
> > + *  BSD LICENSE
> > + *
> > + *  Copyright(c) 2015 Broadcom Corporation.  All rights reserved.
> > + *
> > + *  Redistribution and use in source and binary forms, with or without
> > + *  modification, are permitted provided that the following conditions
> > + *  are met:
> > + *
> > + *    * Redistributions of source code must retain the above copyright
> > + *      notice, this list of conditions and the following disclaimer.
> > + *    * Redistributions in binary form must reproduce the above copyright
> > + *      notice, this list of conditions and the following disclaimer in
> > + *      the documentation and/or other materials provided with the
> > + *      distribution.
> > + *    * Neither the name of Broadcom Corporation nor the names of its
> > + *      contributors may be used to endorse or promote products derived
> > + *      from this software without specific prior written permission.
> > + *
> > + *  THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
> > + *  "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
> > + *  LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
> > + *  A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
> > + *  OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
> > + *  SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
> > + *  LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
> > + *  DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
> > + *  THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
> > + *  (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
> > + *  OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
> > + */
> > +
> > +/dts-v1/;
> > +
> > +#include "bcm-nsp.dtsi"
> > +
> > +/ {
> > +	model = "NorthStar Plus SVK (BCM958625K)";
> > +	compatible = "brcm,bcm58625", "brcm,nsp";
> > +
> > +	aliases {
> > +		serial0 = &uart0;
> > +		serial1 = &uart1;
> > +	};
> > +
> > +	chosen {
> > +		stdout-path = "serial0:115200n8";
> > +	};
> > +};
> > +
> > +&uart0 {
> > +	status = "okay";
> > +};
> > +
> > +&uart1 {
> > +	status = "okay";
> > +};
> > 



More information about the linux-arm-kernel mailing list