[PATCH v5 2/4] Documentation: arm64/arm: dt bindings for numa.
Robert Richter
robert.richter at caviumnetworks.com
Sat Aug 22 08:06:16 PDT 2015
On 14.08.15 22:09:32, Ganapatrao Kulkarni wrote:
> DT bindings for numa map for memory, cores and IOs using
> arm,associativity device node property.
Arnd, Rob,
as the change below suggests the same topology syntax as already
implemented for PPC, could you take a look at this one for arm64?
Please ack the devicetree changes, assuming you are fine with it.
All other review comments are addressed so far and there are no open
issues with the patches. This would help us to further drive this
series upstream.
Many thanks,
-Robert
> Signed-off-by: Ganapatrao Kulkarni <gkulkarni at caviumnetworks.com>
> ---
> Documentation/devicetree/bindings/arm/numa.txt | 212 +++++++++++++++++++++++++
> 1 file changed, 212 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/arm/numa.txt
>
> diff --git a/Documentation/devicetree/bindings/arm/numa.txt b/Documentation/devicetree/bindings/arm/numa.txt
> new file mode 100644
> index 0000000..dc3ef86
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/arm/numa.txt
> @@ -0,0 +1,212 @@
> +==============================================================================
> +NUMA binding description.
> +==============================================================================
> +
> +==============================================================================
> +1 - Introduction
> +==============================================================================
> +
> +Systems employing a Non Uniform Memory Access (NUMA) architecture contain
> +collections of hardware resources including processors, memory, and I/O buses,
> +that comprise what is commonly known as a NUMA node.
> +Processor accesses to memory within the local NUMA node is generally faster
> +than processor accesses to memory outside of the local NUMA node.
> +DT defines interfaces that allow the platform to convey NUMA node
> +topology information to OS.
> +
> +==============================================================================
> +2 - arm,associativity
> +==============================================================================
> +The mapping is done using arm,associativity device property.
> +this property needs to be present in every device node which needs to to be
> +mapped to numa nodes.
> +
> +arm,associativity property is set of 32-bit integers which defines level of
> +topology and boundary in the system at which a significant difference in
> +performance can be measured between cross-device accesses within
> +a single location and those spanning multiple locations.
> +The first cell always contains the broadest subdivision within the system,
> +while the last cell enumerates the individual devices, such as an SMT thread
> +of a CPU, or a bus bridge within an SoC".
> +
> +ex:
> + /* board 0, socket 0, cluster 0, core 0 thread 0 */
> + arm,associativity = <0 0 0 0 0>;
> +
> +==============================================================================
> +3 - arm,associativity-reference-points
> +==============================================================================
> +This property is a set of 32-bit integers, each representing an index into
> +the arm,associativity nodes. The first integer is the most significant
> +NUMA boundary and the following are progressively less significant boundaries.
> +There can be more than one level of NUMA.
> +
> +Ex:
> + arm,associativity-reference-points = <0 1>;
> + The board Id(index 0) used first to calculate the associativity (node
> + distance), then follows the socket id(index 1).
> +
> + arm,associativity-reference-points = <1 0>;
> + The socket Id(index 1) used first to calculate the associativity,
> + then follows the board id(index 0).
> +
> + arm,associativity-reference-points = <0>;
> + Only the board Id(index 0) used to calculate the associativity.
> +
> + arm,associativity-reference-points = <1>;
> + Only socket Id(index 1) used to calculate the associativity.
> +
> +==============================================================================
> +4 - Example dts
> +==============================================================================
> +
> +Example: 2 Node system consists of 2 boards and each board having one socket
> +and 8 core in each socket.
> +
> + arm,associativity-reference-points = <0>;
> +
> + memory at 00c00000 {
> + device_type = "memory";
> + reg = <0x0 0x00c00000 0x0 0x80000000>;
> + /* board 0, socket 0, no specific core */
> + arm,associativity = <0 0 0xffff>;
> + };
> +
> + memory at 10000000000 {
> + device_type = "memory";
> + reg = <0x100 0x00000000 0x0 0x80000000>;
> + /* board 1, socket 0, no specific core */
> + arm,associativity = <1 0 0xffff>;
> + };
> +
> + cpus {
> + #address-cells = <2>;
> + #size-cells = <0>;
> +
> + cpu at 000 {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x000>;
> + enable-method = "psci";
> + /* board 0, socket 0, core 0*/
> + arm,associativity = <0 0 0>;
> + };
> + cpu at 001 {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x001>;
> + enable-method = "psci";
> + arm,associativity = <0 0 1>;
> + };
> + cpu at 002 {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x002>;
> + enable-method = "psci";
> + arm,associativity = <0 0 2>;
> + };
> + cpu at 003 {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x003>;
> + enable-method = "psci";
> + arm,associativity = <0 0 3>;
> + };
> + cpu at 004 {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x004>;
> + enable-method = "psci";
> + arm,associativity = <0 0 4>;
> + };
> + cpu at 005 {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x005>;
> + enable-method = "psci";
> + arm,associativity = <0 0 5>;
> + };
> + cpu at 006 {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x006>;
> + enable-method = "psci";
> + arm,associativity = <0 0 6>;
> + };
> + cpu at 007 {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x007>;
> + enable-method = "psci";
> + arm,associativity = <0 0 7>;
> + };
> + cpu at 008 {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x008>;
> + enable-method = "psci";
> + /* board 1, socket 0, core 0*/
> + arm,associativity = <1 0 0>;
> + };
> + cpu at 009 {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x009>;
> + enable-method = "psci";
> + arm,associativity = <1 0 1>;
> + };
> + cpu at 00a {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x00a>;
> + enable-method = "psci";
> + arm,associativity = <0 0 2>;
> + };
> + cpu at 00b {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x00b>;
> + enable-method = "psci";
> + arm,associativity = <1 0 3>;
> + };
> + cpu at 00c {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x00c>;
> + enable-method = "psci";
> + arm,associativity = <1 0 4>;
> + };
> + cpu at 00d {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x00d>;
> + enable-method = "psci";
> + arm,associativity = <1 0 5>;
> + };
> + cpu at 00e {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x00e>;
> + enable-method = "psci";
> + arm,associativity = <1 0 6>;
> + };
> + cpu at 00f {
> + device_type = "cpu";
> + compatible = "arm,armv8";
> + reg = <0x0 0x00f>;
> + enable-method = "psci";
> + arm,associativity = <1 0 7>;
> + };
> + };
> +
> + pcie0: pcie0 at 0x8480,00000000 {
> + compatible = "arm,armv8";
> + device_type = "pci";
> + bus-range = <0 255>;
> + #size-cells = <2>;
> + #address-cells = <3>;
> + reg = <0x8480 0x00000000 0 0x10000000>; /* Configuration space */
> + ranges = <0x03000000 0x8010 0x00000000 0x8010 0x00000000 0x70 0x00000000>; /* mem ranges */
> + /* board 0, socket 0, pci bus 0*/
> + arm,associativity = <0 0 0>;
> + };
> --
> 1.8.1.4
>
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
More information about the linux-arm-kernel
mailing list