[PATCH v2 4/6] ARM: dts: qs600: remove unnecessary i2c pinctrl nodes in board file.

[Srinivas Kandagatla]

This patch removes unnecessary i2c pinctrl nodes in board file, these
are already defined in the soc specific file qcom-apq8064.dtsi.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla at linaro.org>
---
 arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts | 9 ---------
 1 file changed, 9 deletions(-)

diff --git a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
index ebde2b7..06b3a70 100644
--- a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
@@ -21,15 +21,6 @@
 	};
 
 	soc {
-		pinctrl at 800000 {
-			i2c1_pins: i2c1 {
-				mux {
-					pins = "gpio20", "gpio21";
-					function = "gsbi1";
-				};
-			};
-		};
-
 		rpm at 108000 {
 			regulators {
 				vin_lvs1_3_6-supply = <&pm8921_s4>;
-- 
1.9.1