[PATCH v4 0/5] ARM: berlin: PWM support

[Antoine Tenart]

Hi all,

This series adds a driver for the Marvell Berlin PWM controller, which
has 4 channels.

This has been tested on a BG2Q DMP.

Thanks,

Antoine

Changes since v3:
	- Use readl_relaxed
	- Reworked the clk enable / clk disable calls
	- Removed BERLIN_PWM_DISABLE

Changes since v2:
        - Reworked the prescaler/tcnt calculation
        - Added an input clock
        - Updated the documentation
        - Reordered the pwm node
        - Added some definition for BIT()

Changes since v1:
        - Added a sentinel in berlin_pwm_match[]

Antoine Tenart (5):
  pwm: add the Berlin pwm controller driver
  Documentation: bindings: document the Berlin PWM driver
  ARM: berlin: add a PWM node on the BG2Q
  ARM: berlin: add a PWM node on the BG2
  ARM: berlin: add a PWM node on the BG2CD

 .../devicetree/bindings/pwm/pwm-berlin.txt         |  19 ++
 arch/arm/boot/dts/berlin2.dtsi                     |   7 +
 arch/arm/boot/dts/berlin2cd.dtsi                   |   7 +
 arch/arm/boot/dts/berlin2q.dtsi                    |   7 +
 drivers/pwm/Kconfig                                |   9 +
 drivers/pwm/Makefile                               |   1 +
 drivers/pwm/pwm-berlin.c                           | 218 +++++++++++++++++++++
 7 files changed, 268 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pwm/pwm-berlin.txt
 create mode 100644 drivers/pwm/pwm-berlin.c

-- 
2.5.0