[PATCH v3 08/10] Doc: usb: ci-hdrc-usb2: add tx(rx)-burst-config-dword for binding doc

[Peter Chen]

On Fri, Aug 14, 2015 at 10:37:30AM +0200, Lucas Stach wrote:
> Am Freitag, den 07.08.2015, 15:15 +0800 schrieb Peter Chen:
> > It is used to override the default setting for burst size, changing
> > burst size takes effect only when the SBUSCFG.AHBBRST = 0.
> > 
> > Signed-off-by: Peter Chen <peter.chen at freescale.com>
> > ---
> >  Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 10 ++++++++++
> >  1 file changed, 10 insertions(+)
> > 
> > diff --git a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
> > index d52a747..d71ef07 100644
> > --- a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
> > +++ b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
> > @@ -37,6 +37,14 @@ Optional properties:
> >    property is used to change AHB burst configuration, check the chipidea
> >    spec for meaning of each value. If this property is not existed, it
> >    will use the reset value.
> > +- tx-burst-size-dword: it is vendor dependent, the tx burst size in dword
> > +  (4 bytes), This register represents the maximum length of a the burst
> > +  in 32-bit words while moving data from system memory to the USB
> > +  bus, changing this value takes effect only the SBUSCFG.AHBBRST is 0.
> 
> The last bits about SBUSCFG.AHBBRST don't make any sense in the DT
> binding. The DT writer doesn't know about the SBUSCFG.AHBBRST value and
> should not care either.
> If someone sets the burst size to something
> non-standard in the DT, the driver should make sure to enable to
> necessary bits to make this setting take effect.

The SBUSCFG.AHBBRST property description is just above this one,
and the user should read the spec for changing these system
configuration parameters.

This requirement is from the spec, and the code logic makes sure
the burst size changes only when SBUSCFG.AHBBRST is 0, since the
hardware will only change burst size if SBUSCFG.AHBBRST is 0.

> 
> Also both those descriptions are missing a description to what value the
> burst sizes will be set if the DT properties are not found. If it's
> implementation defined spell this out in the doc.

It is optional property, if without this property, it will use the
default value.

> 
> Are there really cases where it makes sense to set RX and TX burst sizes
> to different values?

Yes, the default burst size is the same for all SoCs, but the bus
burst size may be larger for some SoCs.

-- 

Best Regards,
Peter Chen