[PATCH 1/2] clk: add lpc18xx creg clk driver

[Joachim Eastwood]

On 11 August 2015 at 22:41, Michael Turquette <mturquette at baylibre.com> wrote:
> Hi Joachim,
>
> Quoting Joachim Eastwood (2015-07-11 14:48:26)
>> +static void __init lpc18xx_creg_clk_init(struct device_node *np)
>> +{
>> +       const char *clk_32khz_parent;
>> +       struct regmap *syscon;
>> +
>> +       syscon = syscon_node_to_regmap(np->parent);
>> +       if (IS_ERR(syscon)) {
>> +               pr_err("%s: syscon lookup failed\n", __func__);
>> +               return;
>> +       }
>> +
>> +       clk_32khz_parent = of_clk_get_parent_name(np, 0);
>> +
>> +       clk_creg[CREG_CLK_32KHZ] =
>> +               clk_register_creg_clk(&clk_creg_clocks[CREG_CLK_32KHZ],
>> +                                     &clk_32khz_parent, syscon);
>> +
>> +       clk_creg[CREG_CLK_1KHZ] =
>> +               clk_register_creg_clk(&clk_creg_clocks[CREG_CLK_1KHZ],
>> +                                     &clk_creg_clocks[CREG_CLK_32KHZ].name,
>> +                                     syscon);
>> +
>> +       of_clk_add_provider(np, of_clk_src_onecell_get, &clk_base_data);
>> +}
>> +CLK_OF_DECLARE(lpc18xx_creg_clk, "nxp,lpc1850-creg-clk", lpc18xx_creg_clk_init);
>
> I'll ask the same question that Stephen asked in your CCU/CGU driver
> series: is it necessary to use CLK_OF_DECLARE here or can you use the
> platform device model?

The 32 kHz clock from the CREG block is a clock parent to the CGU
block so it's possible that it will required early. This is all
depends on how the boot loader initially configures the CGU.

Currently in the DTS for lpc18xx cgu it has:
clocks = <&xtal>, <&xtal32>, <...>;
xtal32 is just a temporary placeholder until the CREG clock is in place.


Note that while it's possible to use the 32k clock together with PLL0
to generate the main CPU bus clock I doubt it will be common
configuration. It is however fully possible to do.


regards,
Joachim Eastwood