[PATCH 0/6] irqchip: GICv2/v3: Add support for irq_vcpu_affinity

[Eric Auger]

Hi Marc,

The series works fine with KVM platform device passthrough use case
(Calxeda Midway, GICv2, SPI assignment with VFIO). My integration branch
can be found at
https://git.linaro.org/people/eric.auger/linux.git/shortlog/refs/heads/v4.2-rc6-irq-forward-v3
if useful.

Tested-by: Eric Auger <eric.auger at linaro.org>

Best Regards

Eric
On 07/09/2015 03:19 PM, Marc Zyngier wrote:
> The GICv2 and GICv3 architectures allow an active physical interrupt
> to be forwarded to a guest, and the guest to indirectly perform the
> deactivation of the interrupt by performing an EOI on the virtual
> interrupt (see for example the GICv2 spec, 3.2.1).
> 
> This allows some substantial performance improvement for level
> triggered interrupts that otherwise have to be masked/unmasked in
> VFIO, not to mention the required trap back to KVM when the guest
> performs an EOI.
> 
> To enable this, the GICs need to be switched to a different EOImode,
> where a taken interrupt can be left "active" (which prevents the same
> interrupt from being taken again), while other interrupts are still
> being processed normally.
> 
> We also use the new irq_set_vcpu_affinity hook that was introduced for
> Intel's "Posted Interrupts" to determine whether or not to perform the
> deactivation at EOI-time.
> 
> As all of this only makes sense when the kernel can behave as a
> hypervisor, we only enable this mode on detecting that the kernel was
> actually booted in HYP mode, and that the GIC supports this feature.
> 
> This series is a complete rework of a RFC I sent over a year ago:
> 
> http://lists.infradead.org/pipermail/linux-arm-kernel/2014-June/266328.html
> 
> Since then, a lot has been either merged (the irqchip_state) or reworked
> (my active-timer series: http://www.spinics.net/lists/kvm/msg118768.html),
> and this implements the last few bits for Eric Auger's series to
> finally make it into the kernel:
> 
> https://lkml.org/lkml/2015/7/2/268
> https://lkml.org/lkml/2015/7/6/291
> 
> With all these patches combined, physical interrupt routing from the
> kernel into a VM becomes possible.
> 
> This has been tested on Juno (GICv2) and FastModel (GICv3). A branch
> is available at:
> 
> git://git.kernel.org/pub/scm/linux/kernel/git/maz/arm-platforms.git irq/gic-irq-vcpu-affinity
> 
> Marc Zyngier (6):
>   irqchip: GICv3: Convert to EOImode == 1
>   irqchip: GIC: Convert to EOImode == 1
>   irqchip: GICv3: Skip LPI deactivation
>   irqchip: GIC: Use chip_data instead of handler_data for cascaded
>     interrupts
>   irqchip: GICv3: Don't deactivate interrupts forwarded to a guest
>   irqchip: GIC: Don't deactivate interrupts forwarded to a guest
> 
>  drivers/irqchip/irq-gic-v3.c       | 57 +++++++++++++++++++++++++++++++--
>  drivers/irqchip/irq-gic.c          | 64 +++++++++++++++++++++++++++++++++++---
>  include/linux/irqchip/arm-gic-v3.h |  9 ++++++
>  include/linux/irqchip/arm-gic.h    |  4 +++
>  4 files changed, 126 insertions(+), 8 deletions(-)
>