[RFC/PATCH-v4.2-rc6 0/5] arm: am437x: use TWD/Global timers

[Felipe Balbi]

Hi,

with these patches AM437x devices can use TWD/global timers.

At least TWD is now used as sched_clock() which gives better latency as seen
below. Keep in mind that while I ran cyclictest to have a feel for avg latency
this test was not against an RT kernel, so results should be taken with a
grain of salt.

Also, I'm not 100% sure clock rate is correct. According to TRM, this timer
should run as MPU_CLK/2 which would be 1GHz / 2 = 500MHz, but even though
I'm using dpll_mpu_m2_ck clock, it still shows as 1000MHz.

Are there any other tests I could/should run ? BTW, I boot-tested on AM4372
with and without 'nosmp' on cmdline.

pre-patch:
T: 0 (  245) P:95 I:1000 C:   9995 Min:     24 Act:   31 Avg:   36 Max:     596

post-patch:
T: 0 (  253) P:95 I:1000 C:   9995 Min:     10 Act:   12 Avg:   14 Max:      68

Felipe Balbi (5):
  Revert "ARM: 7655/1: smp_twd: make twd_local_timer_of_register() no-op
    for nosmp"
  arm: boot: dts: am4372: add ARM timers and SCU nodes
  arm: omap2: Kconfig: select TWD and global timer on AM43xx devices
  arm: omap2: timer: simplify omap4_local_timer_init()
  arm: omap2: board-generic: use omap4_local_timer_init for AM437x

 arch/arm/boot/dts/am4372.dtsi       | 21 +++++++++++++++++++++
 arch/arm/kernel/smp_twd.c           |  4 ----
 arch/arm/mach-omap2/Kconfig         |  3 +++
 arch/arm/mach-omap2/board-generic.c |  2 +-
 arch/arm/mach-omap2/timer.c         | 16 ++++------------
 5 files changed, 29 insertions(+), 17 deletions(-)

-- 
2.5.0