[BUG, RFC] MTD Execute in Place on ARM breaks build

[Petr Cvek]

On 8.8.2015 15:47, Russell King - ARM Linux wrote:
> On Sat, Aug 08, 2015 at 01:42:50PM +0200, Arnd Bergmann wrote:
>> A cleaner approach might be to replace xip_currtime() with
>> ktime_get_ns(), and find some other generic interface to replace
>> xip_irqpending.
> 
> Definitely not.
> 
> The issue here is that the kernel sits in flash.  When we want to write
> to flash, we need to switch the flash into a mode where the data
> contained in the flash becomes unreadable - reading from it results in
> status bytes being returned.  Status bytes are not executable.
> 
> To get around that problem, we have a small amount of code in RAM which
> does the flash erasing and/or programming.  This code, however, needs
> to have access to the interrupt controller and timer.
> 
> Calling generic functions that would be part of the paged-out kernel
> image is just not possible; doing so will immediately crash the kernel
> and break what's being achieved here.  You'd need to mark these functions
> and any functions that they then call (including spinlocks, probably
> the entire lockdep infrastructure, etc) with __xipram.  I don't think
> that's feasible.
> 
> In any case, I don't think XIP multiplatform makes any sense what so
> ever.  Needless to say, it _could_ be made to work, but you're likely
> need some complexity, and given that it has very few users, I don't
> think there's much to be gained from putting that work in.  We've even
> talked a few times about removing XIP support altogether.
> 

How often are these chips erased/written? If it is only for system image update,
it could be done with special code (something like BIOS flashing). Reading chip
in XIP mode is more useful IMO.

Anyway, is my patch proposal for build fixing OK?

Cheers,
Petr