[PATCH 08/10] ARM: dts: OMAP5: Use "syscon-phy-power" instead of "ctrl-module" in SATA PHY node

[Roger Quadros]

On 04/08/15 18:30, Kishon Vijay Abraham I wrote:
> Add "syscon-phy-power" property and remove the deprecated "ctrl-module"
> property from SATA PHY node.
> 
> Since "omap_control_sata" devicetree node is no longer used, remove it.
> 
> Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>

Acked-by: Roger Quadros <rogerq at ti.com>

cheers,
-roger

> ---
>  arch/arm/boot/dts/omap5.dtsi |   10 +---------
>  1 file changed, 1 insertion(+), 9 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/omap5.dtsi b/arch/arm/boot/dts/omap5.dtsi
> index f0b6cd6..c3ca5b7 100644
> --- a/arch/arm/boot/dts/omap5.dtsi
> +++ b/arch/arm/boot/dts/omap5.dtsi
> @@ -946,14 +946,6 @@
>  			#thermal-sensor-cells = <1>;
>  		};
>  
> -		omap_control_sata: control-phy at 4a002374 {
> -			compatible = "ti,control-phy-pipe3";
> -			reg = <0x4a002374 0x4>;
> -			reg-names = "power";
> -			clocks = <&sys_clkin>;
> -			clock-names = "sysclk";
> -		};
> -
>  		/* OCP2SCP3 */
>  		ocp2scp at 4a090000 {
>  			compatible = "ti,omap-ocp2scp";
> @@ -968,7 +960,7 @@
>  				      <0x4A096400 0x64>, /* phy_tx */
>  				      <0x4A096800 0x40>; /* pll_ctrl */
>  				reg-names = "phy_rx", "phy_tx", "pll_ctrl";
> -				ctrl-module = <&omap_control_sata>;
> +				syscon-phy-power = <&scm_conf 0x374>;
>  				clocks = <&sys_clkin>, <&sata_ref_clk>;
>  				clock-names = "sysclk", "refclk";
>  				#phy-cells = <0>;
>