[RFC PATCH 1/5] spi: introduce flag for memory mapped read

[Vignesh R]

On 08/05/2015 10:51 AM, Michal Suchanek wrote:
> Hello,
> 
> On 4 August 2015 at 19:59, R, Vignesh <vigneshr at ti.com> wrote:
>>
>>
>> On 8/4/2015 9:21 PM, Mark Brown wrote:
>>> On Mon, Aug 03, 2015 at 10:27:19AM +0530, Vignesh R wrote:
>>>
>>>> @use_mmap_mode: Some SPI controller chips are optimized for interacting
>>>> with serial flash memories. These chips have memory mapped interface,
>>>> through which entire serial flash memory slave can be read/written as if
>>>> though they are physical memories (like RAM). Using this interface,
>>>> flash can be accessed using memcpy() function and the spi controller
>>>> hardware will take care of communicating with serial flash over SPI.
>>>> Setting this flag will indicate the SPI controller driver that the
>>>> spi_message is from mtd layer to read from/write to flash. The SPI
>>>> master driver can then appropriately switch the controller to memory
>>>> mapped interface to read from/write to flash, based on this flag (See
>>>> drivers/spi/spi-ti-qspi.c for example).
>>>> NOTE: If the SPI controller chip lacks memory mapped interface, then the
>>>> driver will ignore this flag and use normal SPI protocol to read
>>>> from/write to flash. Communication with non-flash SPI devices is not
>>>> possible using the memory mapped interface.
>>>
>>> I still can't tell from the above what this interface is supposed to do.
>>> It sounds like the use of memory mapped mode is supposed to be
>>> transparent to users, it should just affect how the controller interacts
>>> with the hardware, but if that's the case why do we need to expose it to
>>> users at all?  Shouldn't the driver just use memory mapped mode if it's
>>> faster?
>>>
>>
>> TI QSPI controller has two blocks:
>> 1. SPI_CORE: This is generic(normal) spi mode. This can be used to
>> communicate with any SPI devices (serial flashes as well as non-flash
>> devices like touchscreen).
>> 2. SFI_MM_IF(SPI memory mapped interface): The SFI_MM_IF block only
>> allows reading and writing to an SPI flash device only. Used to speed up
>> flash reads. It _cannot_ be used to communicate with non flash devices.
>> Now, the spi_message that ti-qspi receives in transfer_one() callback
>> can be from mtd device(in which case SFI_MM_IF can be used) or from any
>> other non flash SPI device (in which case SFI_MM_IF must not be used
>> instead SPI_CORE is to be used) but there is no way(is there?) to
>> distinguish where spi_message is from. Therefore I introduced flag
>> (use_mmap_mode) to struct spi_message. mtd driver will set flag to true,
>> this helps the ti-qspi driver to determine that the user is flash device
>> and thus can do read via SFI_MM_IF. If this flag is not set then the
>> user is assumed to be non flash SPI driver and will use SPI_CORE block
>> to communicate.
>>
>> On the whole, I just need a way to determine that the user is a flash
>> device in order to switch to memory mapped interface.
>>
> 
> Maybe it can be set on the SPI slave rather than each message.

You mean to add flag to spi_device struct? That's ok for me.

-- 
Regards
Vignesh