[PATCH v3] media: atmel-isi: parse the DT parameters for vsync/hsync/pixclock polarity

[Laurent Pinchart]

Hi Josh,

Thank you for the patch.

On Tuesday 04 August 2015 17:37:49 Josh Wu wrote:
> This patch will get the DT parameters of vsync/hsync/pixclock polarity, and
> pass to driver.
> 
> Also add a debug information for test purpose.
> 
> Signed-off-by: Josh Wu <josh.wu at atmel.com>

Reviewed-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>

> ---
> 
> Changes in v3:
> - add embedded sync dt property support.
> 
> Changes in v2:
> - rewrite the debug message and add pix clock polarity setup thanks to
>   Laurent.
> - update the commit log.
> 
>  drivers/media/platform/soc_camera/atmel-isi.c | 15 +++++++++++++++
>  1 file changed, 15 insertions(+)
> 
> diff --git a/drivers/media/platform/soc_camera/atmel-isi.c
> b/drivers/media/platform/soc_camera/atmel-isi.c index fead841..4efc939
> 100644
> --- a/drivers/media/platform/soc_camera/atmel-isi.c
> +++ b/drivers/media/platform/soc_camera/atmel-isi.c
> @@ -1061,6 +1061,11 @@ static int isi_camera_set_bus_param(struct
> soc_camera_device *icd) if (common_flags & V4L2_MBUS_PCLK_SAMPLE_FALLING)
>  		cfg1 |= ISI_CFG1_PIXCLK_POL_ACTIVE_FALLING;
> 
> +	dev_dbg(icd->parent, "vsync active %s, hsync active %s, sampling on pix
> clock %s edge\n", +		common_flags & V4L2_MBUS_VSYNC_ACTIVE_LOW ? "low" :
> "high",
> +		common_flags & V4L2_MBUS_HSYNC_ACTIVE_LOW ? "low" : "high",
> +		common_flags & V4L2_MBUS_PCLK_SAMPLE_FALLING ? "falling" : "rising");
> +
>  	if (isi->pdata.has_emb_sync)
>  		cfg1 |= ISI_CFG1_EMB_SYNC;
>  	if (isi->pdata.full_mode)
> @@ -1148,6 +1153,16 @@ static int atmel_isi_parse_dt(struct atmel_isi *isi,
>  		return -EINVAL;
>  	}
> 
> +	if (ep.bus.parallel.flags & V4L2_MBUS_HSYNC_ACTIVE_LOW)
> +		isi->pdata.hsync_act_low = true;
> +	if (ep.bus.parallel.flags & V4L2_MBUS_VSYNC_ACTIVE_LOW)
> +		isi->pdata.vsync_act_low = true;
> +	if (ep.bus.parallel.flags & V4L2_MBUS_PCLK_SAMPLE_FALLING)
> +		isi->pdata.pclk_act_falling = true;
> +
> +	if (ep.bus_type == V4L2_MBUS_BT656)
> +		isi->pdata.has_emb_sync = true;
> +
>  	return 0;
>  }

-- 
Regards,

Laurent Pinchart