[PATCH v6 2/3] ARM: pxa: mainstone: use new pxa_cplds driver
Robert Jarzmik
robert.jarzmik at free.fr
Mon Apr 27 13:17:19 PDT 2015
As the interrupt handling was transferred to the pxa_cplds driver,
make the switch in mainstone platform code.
Fixes: 157d2644cb0c ("ARM: pxa: change gpio to platform device")
Signed-off-by: Robert Jarzmik <robert.jarzmik at free.fr>
---
arch/arm/mach-pxa/include/mach/mainstone.h | 6 +-
arch/arm/mach-pxa/mainstone.c | 115 +++++++----------------------
2 files changed, 31 insertions(+), 90 deletions(-)
diff --git a/arch/arm/mach-pxa/include/mach/mainstone.h b/arch/arm/mach-pxa/include/mach/mainstone.h
index 1bfc4e8..e82a7d3 100644
--- a/arch/arm/mach-pxa/include/mach/mainstone.h
+++ b/arch/arm/mach-pxa/include/mach/mainstone.h
@@ -120,7 +120,9 @@
#define MST_PCMCIA_PWR_VCC_50 0x4 /* voltage VCC = 5.0V */
/* board specific IRQs */
-#define MAINSTONE_IRQ(x) (IRQ_BOARD_START + (x))
+#define MAINSTONE_NR_IRQS IRQ_BOARD_START
+
+#define MAINSTONE_IRQ(x) (MAINSTONE_NR_IRQS + (x))
#define MAINSTONE_MMC_IRQ MAINSTONE_IRQ(0)
#define MAINSTONE_USIM_IRQ MAINSTONE_IRQ(1)
#define MAINSTONE_USBC_IRQ MAINSTONE_IRQ(2)
@@ -136,6 +138,4 @@
#define MAINSTONE_S1_STSCHG_IRQ MAINSTONE_IRQ(14)
#define MAINSTONE_S1_IRQ MAINSTONE_IRQ(15)
-#define MAINSTONE_NR_IRQS (IRQ_BOARD_START + 16)
-
#endif
diff --git a/arch/arm/mach-pxa/mainstone.c b/arch/arm/mach-pxa/mainstone.c
index 78b84c0..2c0658c 100644
--- a/arch/arm/mach-pxa/mainstone.c
+++ b/arch/arm/mach-pxa/mainstone.c
@@ -13,6 +13,7 @@
* published by the Free Software Foundation.
*/
#include <linux/gpio.h>
+#include <linux/gpio/machine.h>
#include <linux/init.h>
#include <linux/platform_device.h>
#include <linux/syscore_ops.h>
@@ -122,92 +123,6 @@ static unsigned long mainstone_pin_config[] = {
GPIO1_GPIO | WAKEUP_ON_EDGE_BOTH,
};
-static unsigned long mainstone_irq_enabled;
-
-static void mainstone_mask_irq(struct irq_data *d)
-{
- int mainstone_irq = (d->irq - MAINSTONE_IRQ(0));
- MST_INTMSKENA = (mainstone_irq_enabled &= ~(1 << mainstone_irq));
-}
-
-static void mainstone_unmask_irq(struct irq_data *d)
-{
- int mainstone_irq = (d->irq - MAINSTONE_IRQ(0));
- /* the irq can be acknowledged only if deasserted, so it's done here */
- MST_INTSETCLR &= ~(1 << mainstone_irq);
- MST_INTMSKENA = (mainstone_irq_enabled |= (1 << mainstone_irq));
-}
-
-static struct irq_chip mainstone_irq_chip = {
- .name = "FPGA",
- .irq_ack = mainstone_mask_irq,
- .irq_mask = mainstone_mask_irq,
- .irq_unmask = mainstone_unmask_irq,
-};
-
-static void mainstone_irq_handler(unsigned int irq, struct irq_desc *desc)
-{
- unsigned long pending = MST_INTSETCLR & mainstone_irq_enabled;
- do {
- /* clear useless edge notification */
- desc->irq_data.chip->irq_ack(&desc->irq_data);
- if (likely(pending)) {
- irq = MAINSTONE_IRQ(0) + __ffs(pending);
- generic_handle_irq(irq);
- }
- pending = MST_INTSETCLR & mainstone_irq_enabled;
- } while (pending);
-}
-
-static void __init mainstone_init_irq(void)
-{
- int irq;
-
- pxa27x_init_irq();
-
- /* setup extra Mainstone irqs */
- for(irq = MAINSTONE_IRQ(0); irq <= MAINSTONE_IRQ(15); irq++) {
- irq_set_chip_and_handler(irq, &mainstone_irq_chip,
- handle_level_irq);
- if (irq == MAINSTONE_IRQ(10) || irq == MAINSTONE_IRQ(14))
- set_irq_flags(irq, IRQF_VALID | IRQF_PROBE | IRQF_NOAUTOEN);
- else
- set_irq_flags(irq, IRQF_VALID | IRQF_PROBE);
- }
- set_irq_flags(MAINSTONE_IRQ(8), 0);
- set_irq_flags(MAINSTONE_IRQ(12), 0);
-
- MST_INTMSKENA = 0;
- MST_INTSETCLR = 0;
-
- irq_set_chained_handler(PXA_GPIO_TO_IRQ(0), mainstone_irq_handler);
- irq_set_irq_type(PXA_GPIO_TO_IRQ(0), IRQ_TYPE_EDGE_FALLING);
-}
-
-#ifdef CONFIG_PM
-
-static void mainstone_irq_resume(void)
-{
- MST_INTMSKENA = mainstone_irq_enabled;
-}
-
-static struct syscore_ops mainstone_irq_syscore_ops = {
- .resume = mainstone_irq_resume,
-};
-
-static int __init mainstone_irq_device_init(void)
-{
- if (machine_is_mainstone())
- register_syscore_ops(&mainstone_irq_syscore_ops);
-
- return 0;
-}
-
-device_initcall(mainstone_irq_device_init);
-
-#endif
-
-
static struct resource smc91x_resources[] = {
[0] = {
.start = (MST_ETH_PHYS + 0x300),
@@ -487,11 +402,37 @@ static struct platform_device mst_gpio_keys_device = {
},
};
+static struct resource mst_cplds_resources[] = {
+ [0] = {
+ .start = MST_FPGA_PHYS + 0xc0,
+ .end = MST_FPGA_PHYS + 0xe0 - 1,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ .start = PXA_GPIO_TO_IRQ(0),
+ .end = PXA_GPIO_TO_IRQ(0),
+ .flags = IORESOURCE_IRQ | IORESOURCE_IRQ_LOWEDGE,
+ },
+ [2] = {
+ .start = MAINSTONE_IRQ(0),
+ .end = MAINSTONE_IRQ(15),
+ .flags = IORESOURCE_IRQ,
+ },
+};
+
+static struct platform_device mst_cplds_device = {
+ .name = "pxa_cplds_irqs",
+ .id = -1,
+ .resource = &mst_cplds_resources[0],
+ .num_resources = 3,
+};
+
static struct platform_device *platform_devices[] __initdata = {
&smc91x_device,
&mst_flash_device[0],
&mst_flash_device[1],
&mst_gpio_keys_device,
+ &mst_cplds_device,
};
static struct pxaohci_platform_data mainstone_ohci_platform_data = {
@@ -718,7 +659,7 @@ MACHINE_START(MAINSTONE, "Intel HCDDBBVA0 Development Platform (aka Mainstone)")
.atag_offset = 0x100, /* BLOB boot parameter setting */
.map_io = mainstone_map_io,
.nr_irqs = MAINSTONE_NR_IRQS,
- .init_irq = mainstone_init_irq,
+ .init_irq = pxa27x_init_irq,
.handle_irq = pxa27x_handle_irq,
.init_time = pxa_timer_init,
.init_machine = mainstone_init,
--
2.1.4
More information about the linux-arm-kernel
mailing list