[PATCHv2 2/4] ARM: socfpga: disable the sdmmc, and uart nodes in the base arria10

[dinguyen at opensource.altera.com]

From: Dinh Nguyen <dinguyen at opensource.altera.com>

Add status = "disabled" in the base DTSI for Arria10.  The SDMMC and uart
nodes should be enabled in the appropriate board file.

Signed-off-by: Dinh Nguyen <dinguyen at opensource.altera.com>
---
 arch/arm/boot/dts/socfpga_arria10.dtsi | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/arch/arm/boot/dts/socfpga_arria10.dtsi b/arch/arm/boot/dts/socfpga_arria10.dtsi
index 69d616a..d843609 100644
--- a/arch/arm/boot/dts/socfpga_arria10.dtsi
+++ b/arch/arm/boot/dts/socfpga_arria10.dtsi
@@ -268,6 +268,7 @@
 			reg = <0xff808000 0x1000>;
 			interrupts = <0 98 IRQ_TYPE_LEVEL_HIGH>;
 			fifo-depth = <0x400>;
+			status = "disabled";
 		};
 
 		ocram: sram at ffe00000 {
@@ -324,6 +325,7 @@
 			interrupts = <0 110 IRQ_TYPE_LEVEL_HIGH>;
 			reg-shift = <2>;
 			reg-io-width = <4>;
+			status = "disabled";
 		};
 
 		uart1: serial1 at ffc02100 {
@@ -332,6 +334,7 @@
 			interrupts = <0 111 IRQ_TYPE_LEVEL_HIGH>;
 			reg-shift = <2>;
 			reg-io-width = <4>;
+			status = "disabled";
 		};
 
 		usbphy0: usbphy at 0 {
-- 
2.2.1