ARM errata 430973 on multi platform kernels

[Tony Lindgren]

* Matthijs van Duin <matthijsvanduin at gmail.com> [150405 16:53]:
> Cortex-A8 errata doc states in its workaround for erratum 430973:
> 
> > By default, the BTB Invalidate instruction is treated as a NOP on Cortex-A8.
> > However, it is possible to enable the BTB Invalidate instruction such that it
> > actually does a full invalidate of the BTB by setting the IBE bit (bit 6) in
> > the CP15 Auxiliary Control Register. As a consequence of erratum 687067, the
> > L1 System Array Debug Register should be cleared to 0 before the IBE bit is
> > set using the following code sequence:
> > MOV r1, #0
> > MCR p15, 0, r1, c15, c1, 0            ; write instruction data 0 register
> > MRC p15, 0, R1, c1, c0, 1             ; read Aux Ctl Register
> > ORR R1, R1 #(1 << 6)                  ; set IBE to 1
> > MCR p15, 0, R1, c1, c0, 1             ; write Aux Ctl Register
> > The above code needs to be executed in Secure state. ARM Limited recommends
> > that this code is added to the boot monitor.
> 
> The 430973 workaround code in proc-v7.S will do absolutely nothing if
> executed in non-secure state. Ditto for the 458693 workaround, and the
> 460075 workaround should trigger an undefined instruction exception.
> Maybe linux is started in secure mode on some targets and this code
> was written for one of those?

That's only for HS omaps, for those we currently only do it in the
nokia_n900_legacy_init that calls rx51_secure_update_aux_cr.

> I scanned DM814x secure ROM for any (ARM or Thumb) write to
> Instruction L1 System Array Debug Register 0, but I found none, hence
> my warning to watch out for erratum 687067.

OK
 
> Adding the full set of BTB invalidates while making sure IBE is
> disabled on sufficiently recent Cortex-A8 revisions would be optimal
> for the Cortex-A8. But, apparently (based on the description of the
> ARMv7 CPUID registers) there are also processors which only require
> BTB invalidates when code is modified, but not when context-switching,
> so there may be performance considerations there...

Attempting to summarize all that's been discussed.. It sounds like we
need the following implemented:

1. For cortex-a8 revisions affected by 458693, we can do a custom
   cpu_v7_switch_mm function that always does flush BTAC/BTB.

2. For HS cortex-a8 processors other than n900 affected by 458693,
   we need to implement functions similar to rx51_secure_update_aux_cr,
   the bootrom on n900 is different from TI HS omaps so the SMC call
   numbering may be different.

3. For later cortex-a8 processors not affected by 458693, we need
   to clear IBE bit to avoid erratum 687067.

Regards,

Tony