[STLinux Kernel] [PATCH 0/4] clk: Provide support for always-on clocks
Peter Griffin
peter.griffin at linaro.org
Thu Apr 2 01:12:10 PDT 2015
Hi Lee,
On Fri, 27 Feb 2015, Lee Jones wrote:
> Some hardware contains bunches of clocks which must never be
> turned off. If drivers a) fail to obtain a reference to any
> of these or b) give up a previously obtained reference
> during suspend, the common clk framework will attempt to
> disable them and a platform can fail irrecoverably as a
> result. Usually the only way to recover from these failures
> is to reboot.
>
> To avoid either of these two scenarios from catastrophically
> disabling an otherwise perfectly healthy running system,
> clocks can be identified as always-on using this property
> from inside a clocksource's node. The CLK_IGNORE_UNUSED
> flag will be applied to each clock instance named in this
> property, thus preventing them from being shut down by the
> framework.
Great stuff.
One minor comment is that assuming this works on stih407 and stih410
to the extent that the platform can now boot without clk_ignore_unused
kenel parameter then you should have an additional patch to remove
clk_ignore_unused from the default bootargs in stih407-b2120.dts and
stih410-b2120.dts files.
Maxime - Is it possible for you to test this series on stih418-b2199 as
a well? As it could most likely also be removed from stih418-b2199.dts file
to, but neither Lee or myself have the hardware to test.
Apart from that, for the series: -
Acked-by: Peter Griffin <peter.griffin at linaro.org>
regards,
Peter.
More information about the linux-arm-kernel
mailing list